080252-1 Briggs and Stratton Engine - Parts

Crank-Bell Add to cart

Washer Add to cart

Knob-control The control knob is part of the speed control panel. This item is made of plastic and is sold individually. It is an authentic OEM sourced item which is specifically produced for use with blowers, eng... Add to cart

Seal-o Ring This authentic manufacturer-supplied washer is specially designed for use with Briggs and Stratton engines that are commonly installed on lawn and garden equipment. It is a special hardware that helps... Add to cart

Clip-control Rod This control rod clip is a genuine OEM replacement designed for small engine throttle linkages. It secures the control rod in place to help maintain consistent throttle response and stable engine spee... Add to cart

Spring-needle Valve The needle valve spring goes next to the idle mixture valve and is made of metal. This is available as an individual replacement part. This authentic item is supplied directly from the original equipm... Add to cart

Spring-pump Diaph This is a genuine Briggs & Stratton and Toro part sourced directly from the manufacturer for use in engines, generators, and blower-vacuums. The pump diaphragm spring attaches to the spring cap and is... Add to cart

Screw It is a genuine OEM sourced replacement screw which is specially designed for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. Please refer to the appropriate diag... Add to cart

Link-choke This choke link is an OEM direct from Briggs & Stratton. The metal component is made for use with many small engines. The choke link is fastened between the choke thermostat and the carburetor. This i... Add to cart

Clutch-starter Hard starting may come from the recoil system instead of the carburetor or spark plug. If the rope pulls but the engine does not turn, the starter clutch may be worn, dirty, or jammed. The clutch turn... Add to cart

Pin-Shaft Add to cart

Clamp-tube Add to cart