General Electric Refrigerator Dispensers

This part mounts in the ice dispenser. The crank no longer comes with this part but you can use original crank. The crank is sold separately depending on the model number of your appliance.

This part is a possible option when ice door won't open or shut properly or when water is not dispensing.

Once a glass is pressed against the actuator pad it will cause the dispenser to deliver ice or water when activated.

This paddle, when your glass is pushed against it, activates the dispenser to release the ice through the funnel.

This part is the replacement dispenser grille for your refrigerator. It is made of black plastic and is approximately 10 inches wide and 4 inches deep. The dispenser grill sits at the bottom of your ice dispenser assembly and catches any spills when your ice or water dispenser is running. If your dispenser grille/drip tray is missing or damaged, this is the part that replaces it. To replace the dispenser grille, simply remove it and insert the new one. This part is sold individually and is and authentic OEM part sourced directly from the manufacturer.

NOTE: Control board is NOT included. Must be ordered separately.

The door recess crank for your refrigerator is located inside the water dispenser assembly. To access this part, you will need to take apart the dispenser assembly. To do this, you will need a putty knife and a Phillips screwdriver. If your dispenser door will not close properly, or ice is not dispensing properly, you may have a damaged door recess crank. This part is made of white plastic and is sold individually.

This part works in conjunction with the ice chute door.

The dispenser lever releases ice or water when you press the lever.