The flat style gas oven igniter included in this kit has a body length of 3-3/4". This kit comes with a mounting bracket and a wire connector with a plug. *Please note: the connector plug might need to be removed and spliced to range wiring using porcelain wire nuts. This part is used to heat your oven.

Sold individually.

This bake element is found on the bottom of the oven. This part is made of metal, and is approximately 20 inches in length and 18 inches in width.

Sold individually.

This part is a replacement lens for your oven or range. The lens is red in color, and when the elements are turned on, the light behind the lens will turn on to inform the user that the element is, in fact, on. The lens is a little less than half an inch in diameter and is made of plastic. If the light behind the lens still works, you should be able to simply remove the front panel and pop the damaged lens out of position, then replace it with the new one. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Sold individually.

The depth of the screw-on terminals is 2-3/4 inches and they are 1-1/4 inches apart. Does NOT include mounting bracket.

Be very careful when handling this igniter as it is very fragile.This igniter has a range of 2.5 to 3.0 amps. Note: This will not replace the flat style igniters. Also known as bake and broil igniter.

This rear drawer support comes with the installation screw. ***NOTE: There has been a factory design change and you must change both rear supports from side to rear.