Roper Dryer Hardware

Roper Dryer Tri Ring

★★★★★

★★★★★

4 Reviews

If you notice that your dryer is noisy or will not tumble, you may need to replace the tri ring. This part is triangular, and is less than an inch in size. Tri rings can be found both on the idler pulley shaft, or on the rear drum roller shaft. In either case, you will need to remove the front panel of the dryer and the drum to access the part for repair. Once you have accessed the damaged tri ring, you will simply need to slip it off and replace it with the new one. This part is sold individually. Be sure to disconnect the power source from the dryer before you begin this repair.

Roper Dryer Single Front Panel Cip

★★★★★

★★★★★

2 Reviews

This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.

Roper Dryer Screw This screw is sold individually.

Roper Dryer Retainer Spring Clip Sold Individually.

Roper Dryer Washer Knob Springclip

★★★★★

★★★★★

1 Review

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Roper Dryer Air Conditioner Cover Screw Sold individually.

Roper Dryer Support Roller Clip Sold Individually.

Roper Dryer Front Top Lock

★★★★★

★★★★★

1 Review

This part is used to secure the top panel to the cabinet. Sold individually.

Roper Dryer Single Access Panel Clip

★★★★★

★★★★★

2 Reviews

Sold individually.

Roper Dryer Refrigerator Single Hex Head Screw Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".