This power relay board helps manage how electricity is distributed to key heating components in an electric range or wall oven. It supports proper temperature control, responds to signals from the control panel, and helps ensure the oven heats steadily and operates normally. A failing board may cause issues like no heat, an oven that won’t start, unresponsive controls, or a blank or flickering display. Replacing it can restore consistent heating and reliable performance, but it’s important to confirm it matches your specific appliance model.
How Buying OEM Parts Can Save You Time and Money
Troubleshooting
This part works with the following products:
Range, Cooktop.
This part works with the following products:
Electrolux, Kenmore.
Part# 316442120 replaces these:
AP5780950, 316442115, 7316442115
Customer Reviews
Average Rating:
★★★★★
★★★★★
2 Reviews
5.0
Filter By Rating:
5 Stars
2
4 Stars
0
3 Stars
0
2 Stars
0
1 Star
0
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Francis B - July 5, 2019
Verified Purchase
came fast just as ordered
part arrived next day, fit with a little tweaking and my range is up and running
★★★★★
★★★★★
David K - December 29, 2023
Verified Purchase
Oven control board
Could not have been easier. Turn off power, Unplug the old card, undo the screws, remove card. Remove spacer legs, from old card, install on new card. Install screws, install all electrical connections.. Turn on power. Turn on oven and test temperature.
< Prev
1
Next >
Customer Repair Stories
Average Repair Rating: 3.3 / 5.0, 1 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Right front burner would not turn off.
Lifted stove top to disconnect burner wires in order to use stove until parts arrived. Remove a bunch of square drive screws to remove back panel from stove. Identify relay board and disconnect wire connectors from it then release several plastic clips and two screws holding board to oven. Install new board and connect wires, No other adjustments were required.
Other Parts Used:
DENNIS from SIERRA VISTA, AZ
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
3 of 3 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
4 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Al
December 8, 2019
After finishing a self clean cycle, our stove now will not stop heating a preset temp. Did the high temp cause this damage and is this the right part?
For model number EW30ES6CGS4
Hello Al, Thank you for the question. This is normally caused by a defective Temperature Sensor, PartSelect Number PS820208. You can also test the sensor to confirm it is defective. Testing the temperature sensor probe on your oven is easy. With the sensor at room temperature, measure the resistance between the two prongs at the end of the sensor connector. The resistance of the sensor should read approximately 1080 – 1090 ohms at room temperature. Hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Darrell
May 18, 2023
Hi, We cant get the bottom element to come on. The element works, I tried switching the leads from the top element and the element works fine. so im assuming its a relay board. But there is 2 boards at the back, Which one would it be that controls the bottom element.
Thanks
For model number EW30ES6CGS2 Electrolux
Hello Darrell, thank you for reaching out. We believe your range is having this problem because of the control board. We recommend you replace the electronic control board, part number PS2378973, to fix the issue. We hope this information is useful!
Cannot get the center element of the triple to turn off. i need the relay board
For model number EW30EF65GWA
Hi Tyron, thank you for reaching out. Checking the relay board, part number PS8692040, will fix this issue. We hope this helps!
Was this helpful?
Thank you for voting!
Brian
January 29, 2025
on my Electrolux stove the triple element is not completely working, only the inner is working. I did an ohm test on the element and I received 3 ohm readings on the element 75.5, 47.7 and 47.7. I do not believe the element is the problem. I was wondering if you can help.
For model number EW30EF65GSC
Hi Brian, thank you for reaching out. Ensure that all the wiring connections to the element are secure and not damaged. As you have already checked the element and it is fine, we would suggest checking the relay board, part number PS8692040. It controls the display and operation of the surface elements. You may need to replace it to fix the issue. We hope this solves your problem!
Fresh Flow Produce Preserver is made for your refrigerator to help keep produce fresh for longer by absorbing the chemical, ethylene, that causes your fruits and vegetables to ripen quicker. Your produce could be fresh f...
Having a problem with a funky-smelling washing machine, or one that just doesnt seem to clean your clothes as well as it used to? Say hello to the Affresh Washing Machine Cleaner by Whirlpool. This powerful washing helpe...
Affresh dishwasher Cleaner is specially formulated to help remove limescale and mineral build-up that can be unsightly and could affect your dishwasher's performance. Each tablet is designed to clean inside your machine ...
Make your cooktop shine with Frigidaire ReadyClean Glass and Ceramic Cleaner. Our scratch-free, streak-free formula removes smudges, grease, burnt-on food, dirt and oil, while protecting and polishing to repel dust and d...
[{"position":0,"name":"Home","title":"Home","url":"/"},{"position":1,"name":"Circuit Board or Touch Pad","title":"Circuit Board or Touch Pad","url":"/Range-Circuit-Boards-and-Touch-Pads.htm"},{"position":2,"name":"316442120","title":"316442120","url":""}]
