Ice Dispenser Door Spring WR2X8663

First disconnect power and turn off water supply.Removes the cover that indicates water and ice settings,removed 4 screws that held the switch assembly on,unplugged wiring harness (left solenoid wires connected.removed screw holding arm that closes door and removed assembly.Covered hole with duct tape ordered parts (which came very quickly turned water and power back on.When new parts came actuator arm was different on door put old one on door and reassembled in reverse order

Followed previous description, when the face plate came off, parts appeared straight forward. I turned off the refringerator at the circuit breaker, so didn't have to move it.

went to the repair site, saw the video and used it to replace the parts. didnt have the hinge assembly which made the flapper stay open and thus caused the icing. recently ordered a replacement and i hope that this will cause the flapper to seat properly.