Surface Element - Right Front WPW10251107

Hi Troy, Thank you for your question. I would suggest testing the parts with a multi meter. For your radiant element, it should have a reading between 0 and 120 ohms. With your switch, when you remove it from your appliance and turn the switch to an on position, if you do not get any readings that means it is your switch that you would need to replace. I hope that helps. Good luck with your repair.

Hi Thompson, Thank you for your question. If one of the left burners is not turning off, the issue is either the electronic control board that the controls the burners on the left side or the burner itself. Before removing and inspecting these parts, unplug the range from the electrical outlet. Inspect the electronic control board for signs of scorching, burn marks wear or damage. If it shows any of these signs, it will need to be replaced. If it is fine, you will need to check the element. Visually inspect it and the wires connected to it for any signs of damage. If there are no visible signs of damage, check it for continuity with a multimeter on the Rx1 setting. Touch each of the terminals one at a time with one probe while holding the other probe to the outside surface of the element. If either terminal show continuity, it is defective. To test the entire element for continuity, place each of the probes on the terminals, one on each. The exact reading you should receive varies between models, refer to your owner’s manual to determine what yours should be, but if any element has a reading outside of 19 to 115 ohms, it is defective. If you do not receive the correct readings from the tests above or find damage on your element, you will need a replacement surface burner element. We hope this helps!