Average Repair Rating: 4.2 / 5.0, 16 reviews.
What's this?
< Prev
1
2
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
ice would not drop
removed the shaft that had worn end-replaced with new one- ok now
Other Parts Used:
terry from panama city beach, FL
Difficulty Level:
Really Easy
Total Repair Time:
More than 2 hours
Tools:
Nutdriver
46 of 82 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Ice maker would run but not dispense ice
Removed the ice bin and turned it over. Removed the old coupling and replaced with the new one, reusing the screw that holds it in place. Then removed the cover plate over the drive shaft that comes out of the door. Pulled out the old shaft and removed the plastic ring that keeps stuff from falling into the motor area. Put the ring onto the new shaft and slowly put the new shaft down into the door until it seated in the motor assembly. Replaced the cover plate with the nut driver and voila! The Ice Age has returned. An easy fix once I determined that the drive shaft end was worn where it engages the coupling, causing it to slip and not move the ice dispenser arm.
removed the drive shaft (6 sided) with seals and replaced it. They last for about 5 years and have to be rotated (flipped over) to continue to use. The shaft metal is a little softer than the drive socket on the motor which, over time will cause the six-sided (12 inch) shaft to round the edges due to torque and pressure on the mixing shaft inside the ice bucket the the door of the freezer.
Long shaft from motor to dispenser was stripped. I removed 2 screws from the shaft holder in door, lifted old shaft out, put new shaft in and replaced the 2 screws. Took 2 mins! Works great!
Other Parts Used:
Dave from LOGANVILLE, GA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Socket set
3 of 3 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Ice dispenser was not engaging.
Removed Ice container; Removed two screws from housing around shaft; Pulled old shaft from freezer door; inserted new shaft in freezer door; replaced housing around shaft; replaced and tightened two screws securing housing; returned ice container. Tested by activating ice dispenser. It worked like new.
Other Parts Used:
Jim from GEORGETOWN, TX
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Socket set
3 of 3 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Ice maker wouldn't work
Simply took out old part, paying attention to how it comes out. Simply put the seal in, followed by the shaft and then place holder on and screw down with the two screws that were with the old part. Abrakadabra! Ice maker working like new!
removed the 2 small screws holding the shaft in place. shaft was worn down on end, causing slippage. ordered new shaft, which arrived in a few days (I've always had good experience with parts select). in the meantime, I read some other repair stories, and one gentleman said he flipped the shaft over and reinstalled it. I did this, replaced the 2 screws, and sure enough it is working perfectly, and I have a spare shaft in case it doesn't last.
Other Parts Used:
Rocco from N MYRTLE BCH, SC
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Socket set
2 of 2 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Ice wouldn’t dispense
Removed the 3 screws. Removed worn part. Inserted new part and replaced screws. Just be sure the new auger lines up with the upper unit that it fits into.
Other Parts Used:
Carol from TUCKER, GA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
2 of 2 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Ice would not dispense and the water filter cap was missing
Remove two screws on shaft cap. Remove cap. Remove shaft and white o ring. Put o ring on new shaft and install. Replace cap and two screws. The cap for the water filter was harder. Without a cap, it took me a few minutes to wiggle the filter out enough that I could put the new cap on. Both parts worked perfectly. Both are horribly designed and will likely need to be replaced again.
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Tom
July 12, 2021
Augur shaft turns but augur inside bucket doesn't turn always so ice isn't dispensed
For model number MSF22C2EXW00
Hello Tom, Thank you for the question. Normally this indicates a stripped and defective Auger Motor. We hope this helps!
This part is a replacement refrigerator drive shaft seal for your refrigerator. The drive shaft seal protects the auger motor from water and condensation that may leak down the drive shaft from the ice bucket. If the sea...
Fresh Flow Produce Preserver is made for your refrigerator to help keep produce fresh for longer by absorbing the chemical, ethylene, that causes your fruits and vegetables to ripen quicker. Your produce could be fresh f...
Having a problem with a funky-smelling washing machine, or one that just doesnt seem to clean your clothes as well as it used to? Say hello to the Affresh Washing Machine Cleaner by Whirlpool. This powerful washing helpe...
Affresh dishwasher Cleaner is specially formulated to help remove limescale and mineral build-up that can be unsightly and could affect your dishwasher's performance. Each tablet is designed to clean inside your machine ...
Make your cooktop shine with Frigidaire ReadyClean Glass and Ceramic Cleaner. Our scratch-free, streak-free formula removes smudges, grease, burnt-on food, dirt and oil, while protecting and polishing to repel dust and d...
[{"position":0,"name":"Home","title":"Home","url":"/"},{"position":1,"name":"Wheel or Roller","title":"Wheel or Roller","url":"/Refrigerator-Wheels-and-Rollers.htm"},{"position":2,"name":"WP2188917","title":"WP2188917","url":""}]
