Tine Row - Kit of 2 W10727426

Removed the old tines by pushing out the clips on the end and then installed the new tines and applied clips - took 10 minutes worked slick and the washer basket looks to be brand.

Removed old tine rows and replaced with the new parts. No tools were needed. Each was replaced one at a time so the old ones could serve as a model for how the new ones were inserted and attached. Not much more complicated than changing a light bulb. Parts appear to be good original equipment quality but quite pricy for these very simple pieces.

Popping out the old tine rows was very simple and required no tools. The only issue was that the spacing of the replacement tines was different from the original parts and there was not enough space between the tines and the basket to snap the clips back on to hold the tine row. I went to my band saw and cut the extended ends off of the clips and then they snapped into place perfectly. This would have been a 20 minute, no tool job if I didn't have to run to the band saw.

Ordered p/n PS10057154, sold as a kit of TWO upper rack tine rows. I received one. Customer service issued a return tag and ordered a second kit, which again was supposed to be two rows. Replacement order arrived with just one. Fortunately, I had expected this and had not yet returned the first kit. Called customer service and told them not to expect the return of the first order.

This kit is sold as fitting several models of Whirlpool and KitchenAid dishwashers, which I verified that my KA was on the list. A minor installation problem occurred when I discovered that the upright tines of this kit don't have the exact same spacing as the KitchenAid originals. The upright tines need to be exactly half the distance between each of the crossbars on the rack below in order to install the three retaining clips found on each row. With the spacing of these tines, there wasn't quite enough room to install the clips. Fortunately, the retaining clips were manufactured with an excessive amount of shoulder on each one. Trimming off the excess material with a fine-toothed hacksaw blade made the clips narrow enough to be used without compromising their ability to hold the tine rows in place. I've used the machine several times now and the clips are holding everything in place as expected.

[img]https://i.ibb.co/9TQB3mC/clips.jpg[/img]

Follow instructions that I found on utube. Easy repair if you take your time and follow the instructions.

The rack itself is rather easy to pull out, pop out the tabs and the rack will slide out. Once you get it out, its a bit more challenging as the rack itself needs to be disassembled. Don't waste a lot of time removing the rails - cut the tines on the old rack and take those off. Unscrew the back of the panel holding the adjustment assembly and the item will come off more quickly. All the rest of this is simple and can be disassembled and snapped back together by hand.

so, so easy! Took out the corroded parts and put in the new. the tine row took the longest - had to unclip and reclip.

Snapped out the old tine-rows and snapped in the new. There were no directions, so I first had to figure out how the units were attached. Once that was determined, it was a snap!

I removed old broken parts and replaced with new.

Didn't work on it