Models > ZISB360DNDII > Instructions

ZISB360DNDII General Electric Refrigerator - Instructions

All Instructions for the ZISB360DNDII
61 - 75 of 122
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Needed new water and ice filter
simply read the instructions
Parts Used:
Refrigerator Ice and Water Filter
  • Marilyn from Green Valley, AZ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
no turn on
with my hands
Parts Used:
Refrigerator Ice and Water Filter
  • edward from orlando, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Nutdriver, Screw drivers
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
bad tsting ice cubes/ water
it was easy. Open the fridge,untwist the old filter. Open the new filter, fill with tap water and twist in place. Run water through it for a few minutes to insure it is working and filters the water.
Parts Used:
Refrigerator Ice and Water Filter
  • Beverly from Jacksonville, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Ice and Water Filter needed replacement
I watched the video, and noticed that they did not even turn off the water. The replacement took less than 30 seconds once the filter was filled with water.
Parts Used:
Refrigerator Ice and Water Filter
  • Tim from Fort Worth, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Water Filter Red Light
Replaced Water Filter (twist off old filter; twist on new.)
Parts Used:
Refrigerator Ice and Water Filter
  • Charles from Foresthill, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Replace Dispencer blade
Removed the exterior 4 screws and 1 holding the metal rod underneath. Sepearated the plastic parts pulled out the dispensing mechanisim. Removed the lock washer, then removed the spacers and blades. Put the new blades in with the spacers and reversed the other steps and done.
Parts Used:
Refrigerator Ice and Water Filter Rear Moving Dispenser Blade Blade - Middle Front Moving Dispenser Blade
  • Leonard from Hawthorne, CA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers
0 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
filter change
easy easy easy!!!!!
Parts Used:
Refrigerator Ice and Water Filter
  • Mary from Elk Grove, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
1 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
water tasted funny
Simply twisted off the old water filter, unwrapped the new one and twisted it on.
Parts Used:
Refrigerator Ice and Water Filter
  • Charles from Enterprise, AL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
0 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
needed to replace the filter
replaced the filter with the new one i purchased
Parts Used:
Refrigerator Ice and Water Filter
  • richard from asheboro, NC
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
0 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Fridge wouldn't keep temp
My son replaced both temperature sensors and the fridge works great now!!! Like brand new again!!!!
Parts Used:
Temperature Sensor
  • Richard from Nesquehoning, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Filter needed replacing
Very easy, unscrew and re-screw new filter in..
Parts Used:
Refrigerator Ice and Water Filter
  • Randell from Rancho Cucamonga, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Removed water filter as I have a whole house filter system.
Just removed the filter and used my hand to attach the water filter bypass cap....did not even need to turn off the water first.
Parts Used:
Refrigerator Bypass
  • Pamela J. from Sun City West, AZ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
water dispensed slow and filters too expensive and not very reliable
I just unscrewed filter and screwed in filter bypass
Parts Used:
Refrigerator Bypass
  • john from selbyville, DE
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
replaced filter
none required
Parts Used:
Refrigerator Ice and Water Filter
  • donnie from metairie, LA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Refrigerator freezing.
Temp. Sensor was under an egg shaped cover on the left side wall in the refrigerator. Remove the cover, cut the two wires to the old sensor and remove it. Connect the new sensor to the two wires using butt connectors. Replace cover and done.
Parts Used:
Temperature Sensor
  • Wayne from Rancho Cordova, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the ZISB360DNDII
61 - 75 of 122
Back to Top