XFD03 Makita Drill - Overview

Sponge A Add to cart

Battery Cover Add to cart

Sponge B Add to cart

Heat Sink Add to cart

Change Lever This is a genuine Makita replacement part, it is sold individually. The purpose of the F/R Change Lever is to change the rotation of the drill motor. It connects to the switch of the tools listed belo... Add to cart

Seal This is an authentic Makita replacement part, sourced from the original manufacturer for use with hammer drills. The special seal is used to provide spacing between the terminal and the housing sets. ... Add to cart

Bit Holder This is a genuine Makita replacement part, it is sold individually. Its purpose is to hold an extra screw bit on the Makita Drills listed below. To mount this to your drill you will need to order screw number 251314-2. Add to cart

Rear Cover This rear housing cover protects the internal motor and electrical components of your cordless drill or impact driver, helping shield them from dust, debris, and impact damage. Made from durable, impa... Add to cart

Brush Holder This is an Authentic Manufacturer Sourced replacement part used on a Makita Drills/Drivers. This part consists of: Plastic Holder Ring, Two (2) Metal Brush Holders With Springs and Two (2) Lead Wires ... Add to cart

Yoke Unit The yoke unit goes between the armature and the gear. It is a genuine item that is supplied by the original equipment manufacturer for use with Makita drills. This part is made of metal and is sold in... Add to cart

18v Lithium-ion Battery Charge This is Makita\'s Lithium-Ion charging system. This charger uses three controls to ensure the best possible charge: Temperature, Voltage, and Current. These controls are monitored by a chip on the ba... Add to cart

Tapping Screw Genuine Manufacturer Sourced replacement part used on a variety of Makita Power Tools. This is a Metal Pan-Head Screw and it is sold individually. This screws is commonly used to hold two pieces of Housing Set together. Add to cart