WRF736SDAB13 Whirlpool Refrigerator - Instructions

Just open the filter and put it in the slot

Lower the filter cover on the refrigerator, twist the old filter to remove it, install the new filter by pushing and twisting it, and close the filter door.
Using a pitcher, run water through the new filter until the excess carbon leavings are out then the water is clear and is drinkable

My original basket only measured like 12” where the description on this website says 15” it perfectly on the left side of the door. Took less than a minute to install.

The light rocker switch wasnt working. I found the part on the web site. It was so easy. I used a screw driver to pop out the old one and pop the new one in. It took 5 min. Thanks!!!

I removed the switch housing (4 screws), replacing the switch in the housing was a snap. It took 5 minutes, cost $8 and light works like new!

Why didn't I order this part and do the repair earlier? Very simple.

Removed old, installed new.

Very simple fix, remove 3 screws, two connectors to the old switch

I watched some of the you tube videos , the repair went well
just followed the directions the repair took less than 30 mins

Access back of unit, lower left corner. Remove wire capacitor retention clip. Unplug cold capacitor, plug in replacement, reinstall wire retention clip, test.

With a screwdriver and a lot of time

Just stood in front of the refrigerator and disconnected the water filter and replaced it with the new one I purchased from by hand

I bought the replacement part from you, it was delivered to my doorstep, and I think I scared off a package pirate. I opened the box and snapped the door bin in place. This was a very challenging task (not). It was so simple....I actually did it.

Removed valve, replaced, slight modification needed on water line going into ice maker.

I followed the instructions in the appliance reference manual, and successfully replaced the water filter in 2 minutes, and reset the water quality indicator.

Replaced motor