WRF736SDAB11 Whirlpool Refrigerator - Instructions

Simply cut the water tube on both sides of connector and push in the new one.

With a screwdriver and a lot of time

My original basket only measured like 12” where the description on this website says 15” it perfectly on the left side of the door. Took less than a minute to install.

I bought the replacement part from you, it was delivered to my doorstep, and I think I scared off a package pirate. I opened the box and snapped the door bin in place. This was a very challenging task (not). It was so simple....I actually did it.

Understood the problem by removing the old dispenser first. That made me realize I also needed the shaft. Went online and matched up all the #’s and the repair went smoothly.

Looked for the same repair on line by model number. I found it, watched the repair, then used those instructions to complete the repair on my refrigerator. The disassembly and reassembly took longer than actually replacing the part. It now works beautifully with NO leaks.

Just open the filter and put it in the slot

Lower the filter cover on the refrigerator, twist the old filter to remove it, install the new filter by pushing and twisting it, and close the filter door.
Using a pitcher, run water through the new filter until the excess carbon leavings are out then the water is clear and is drinkable

We removed the old switch, unplugged it, plugged the new one in and it was easy to do. But when we tried to put the switch back in we had a very hard time doing it. Eventually got it in, but if it had not been for the difficulty we had getting the new switch to snap in to place, it would have taken under 5 minutes.

System not cooling. removed back cover and notice fan not rotating. Looked up unit and found diagram. Ordered motor which was received in less than 5 business days.
Replacement was super easy. Just unscrewed from frame, pulled off fan, put fan on new motor and remounted back in frame. Took 10 minutes tops.

Very simple fix, remove 3 screws, two connectors to the old switch

I watched some of the you tube videos , the repair went well
just followed the directions the repair took less than 30 mins

Removed old, installed new.

I ordered a gasket and follow the instructions, such as warm the gasket, to get it in the door using my fingers, but the door did not close titght enough. The problem could be something else. The initial problem is in there

Just stood in front of the refrigerator and disconnected the water filter and replaced it with the new one I purchased from by hand