Models > WPSQ3120T5WW > Instructions

WPSQ3120T5WW General Electric Washer - Instructions

All Instructions for the WPSQ3120T5WW
46 - 50 of 50
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Dryer Start knob broken inside of stem.
Knob stem was split, leaving the metal bushing on the dryer's Start switch. Used pliers to remove metal collet. Aligned new knob to switch, and firmly pushed replacement part into place. Tested results and found it to be satisfactory.
Parts Used:
Selector Knob with Clip
  • Richard from Bakersfield, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers
Was this instruction helpful to you?
Thank you for voting!
Plastics broke on inside of "Start" knob
Pushed new knob on starter shaft.
Parts Used:
Selector Knob with Clip
  • Peter from Mercerville, NJ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Knob broke inside
Replacement knob went on without tools in 1 second.
Parts Used:
Selector Knob with Clip
  • La Rae from Buda, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Worn out selector knobs
Took off the broken ones and pushed on the new ones. Simple, simple
Parts Used:
Selector Knob with Clip
  • KAREN from CHEVY CHASE, MD
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Worn out dryer knob
I just pulled the old part out using no tools with minimum pressure and pushed the new dryer knob in with no problems at all within approximately 10 seconds.
Parts Used:
Selector Knob with Clip
  • Jesse from Chesapeake, VA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the WPSQ3120T5WW
46 - 50 of 50
Back to Top