WM125 (Type 1) Black and Decker Sawhorse - Overview

Block,slide Mov This item has been sourced from the original manufacturer to be used with work benches from Black and Decker. The slide block attaches to the bottom of the table and is used to allow the table to move... Add to cart

Pivot Nut This is an Authentic OEM sourced replacement part designed for use with Black and Decker Workmate. This item helps to secure the Vise Screw. This Pivot Nut is made out of Plastic and it is Sold Indivi... Add to cart

Vise Screw Add to cart

Crank Arm Genuine Black and Decker replacement part, it is sold individually. This part is used on all the Workmates shown below Its purpose is to open and close the front and rear Vise Jaws on the Workmates. I... Add to cart

Roll Pin This is a genuine manufacturer sourced replacement part. It is specially designed for use with workmate work benches. Its purpose it to help securing the crank arm to the vise screw. This item is made... Add to cart

Nut,wing This is an authentic replacement part manufactured for use with Black and Decker workmate work benches. The wing nut is commonly used to secure the leg to the table. This wing nut does not require too... Add to cart

Washer Add to cart

Washer Add to cart

Knob This is a genuine Black and Decker replacement part, it is sold individually. The Snap-In Knob is installed in the 242302-00 Crank Handle, on the list of Wormates shown below. Its purpose is to rotate... Add to cart

Block,f.slide This is an authentic replacement part manufactured for use with Black and Decker workmate work benches. The special front slide block is used to connect the work board to the frame. The front slide bl... Add to cart

Nut This is an authentic DeWalt replacement part that has been sourced from the original manufacturer to be used with portable work benches. This metal nut is used to fasten the bolt that secures the foot... Add to cart

Bolt Add to cart