This hose clamp extends from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag brand washing machines.
This part helps keep the washer from vigorous shaking during its cycles. They are sold individually. They mount to the front half of the outer tub. Appliance would take 2.
Also known as a bellow. This part is used to keep the clothes inside the tub during the wash cycle. The folds in the bellow allow the tub to move separately from the door during the spin cycle.
This part senses how much water is in the tub and allows it to reach the desired level. For example: A little water equals little pressure and a lot of water means more pressure inside the switch.
replaced door latch but door would not close had to remove latch assembly and reset the latch in the latch assembly. To reset latch in latch assembly you remove the black plastic only on latch assembly then press the spring down with thumb move the black plastic catch back to the latch position. when you remove the black plastic there is four metal switchs and one spring that you have to pay attention too so remove very carefully.
The rear access is attached with 2 Phillips head screws, which I removed. The drain hose is held up with a similar screw. I removed the screw and drained the hose into a bucket. Then I just removed the connector and hoses with my fingers, removed the three 1/2" bolts holding the pump in place, changed the pump and put everything back together. Works like a champ. Quick and easy fix. My only negative comment is that I only needed the impeller, but had to buy the complete pump assembly. Other than that, all fine.
Never thought that the glass would break like it did. Removed the whole door assembly and took out the screws that hold the plastic retaining ring for the glass door. Replaced glass and reassembled the door. Very easy repair. Took about 15 min.
.gif "SUPPLEMENTAL INFORMATION Diagram and Parts List for Maytag Washer")
