VBXR1060T5WB Hotpoint Washer - Overview

Sections of the VBXR1060T5WB

[Viewing 4 of 4]
Keep searches simple, eg. "belt" or "pump".
Tub Bearing Washer – Part Number: WH2X1197
Tub Bearing Washer
PartSelect #: PS271509
Manufacturer #: WH2X1197
$12.16
  Special Order
Washer Split Ring – Part Number: WH02X10265
Washer Split Ring
PartSelect #: PS1766022
Manufacturer #: WH02X10265
This split ring is two inches in diameter.
$18.27
  Special Order
Dishwasher Hose Clamp Kit – Part Number: WH1X2036
Dishwasher Hose Clamp Kit
PartSelect #: PS270806
Manufacturer #: WH1X2036
This hose clamp kit contains two clamps. The smaller of the two is an inch in diameter while the larger of the two is two inches in diameter.
$12.16
  Special Order
Flood Gasket – Part Number: WH1X2729
Flood Gasket
PartSelect #: PS271102
Manufacturer #: WH1X2729
This part is for the hose to outer tub.
$40.92
  Special Order
Screw 10-18 PL – Part Number: WH2X1194
Screw 10-18 PL
PartSelect #: PS271506
Manufacturer #: WH2X1194
Sold individually.
$10.25
  Special Order
Timer – Part Number: WH12X1000
Timer
PartSelect #: PS269722
Manufacturer #: WH12X1000
  No Longer Available
SCREW – Part Number: WH2X1211
SCREW
PartSelect #: PS271523
Manufacturer #: WH2X1211
Sold individually.
$8.25
  Special Order
Lid Switch Assembly – Part Number: WH12X1043
Lid Switch Assembly
PartSelect #: PS269962
Manufacturer #: WH12X1043
The pin on the lid pushes on the lever of the lid switch to tell the machine that the lid is closed.
  No Longer Available
TERMINAL BLOCK Assembly (2 P – Part Number: WB17X5060
TERMINAL BLOCK Assembly (2 P
PartSelect #: PS232622
Manufacturer #: WB17X5060
$72.84
  Special Order
BUTTON PLUG – Part Number: WH1X2745
BUTTON PLUG
PartSelect #: PS271115
Manufacturer #: WH1X2745
$95.65
  Special Order
KIT- 1 SPD WASHER MOTOR – Part Number: WH49X10029
KIT- 1 SPD WASHER MOTOR
PartSelect #: PS783734
Manufacturer #: WH49X10029
This single speed motor kit includes a motor that operates at 1640 revolutions per minute.
  No Longer Available
END CAP Right Hand BK – Part Number: WH42X10734
END CAP Right Hand BK
PartSelect #: PS1559772
Manufacturer #: WH42X10734
$18.57
  Special Order

Questions And Answers for VBXR1060T5WB

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Common Symptoms of the VBXR1060T5WB

[Viewing 2 of 2]
Leaking
Fixed by
these parts
Fixing Fixing Fixing
Show All
Will not agitate
Fixed by
these parts
Fixing Fixing
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Lid switch failed
First removed front washer access panel.
Next: removed top panel torx screws and disconnected lid switch wiring connector
Next: removed washer top/lid
Next: removed inoperative lid switch (two phillips head screws)
Next: installed new lid switch and screws
Next: installed washer top and connected lid switch wire connector
Next: installed control panel and screws
Next: tested installation
Next: installed front washer access panel
Easy repair. FYI, Parts Select had best price and part arrived within two days of ordering! Highly recommend them for your parts.
Parts Used:
Lid Switch Assembly
  • Stephen from Woodbridge, VA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
35 of 47 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
hardest part was getting the knobs off front - there is a small white plastic piece that pops off the shaft and then its easy from there
Remove the plastic piece that holds the timer knob - remove knob - unscrew front panel from top of washer and pull off - remove screws from timer and replace with new and reassemble. Toughest part was removing the timer knob
Parts Used:
Timer
  • Roger from South Bend, IN
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
17 of 19 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The plastic "ears" on the timer assembly had broken off. So when you tried to turn the knob, it would just spin without contacting the gears.
I first removed the screws from the top of the washer electric panel. Then pulled it forward. I then removed the plastic clip from behind the knob. Then I removed the screw holding the timer in place. And then removed the one single wire and the connecting plug. I then plug both wire assemblies in to the new one, slid both ears under the brackets and inserted the one screw. Then just put the screws back in the top. It works great!!!!!
Parts Used:
Timer
  • Randy from Athens, IL
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Screw drivers
9 of 9 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!