UT80522 Homelite Pressure Washer - Overview
Models starting with UT80522
Click on the best match to narrow your results.
- UT80522 Homelite Pressure Washer (Pressure Washer)
- UT80522A Homelite Pressure Washer (Pressure Washer)
- UT80522B Homelite Pressure Washer (2700 PSI Gas Pressure Washer)
- UT80522D Homelite Pressure Washer (Pressure Washer)
- UT80522E Homelite Pressure Washer (Pressure Washer)
- UT80522F Homelite Pressure Washer (Pressure Washer)
- UT80522G Homelite Pressure Washer (Homelite Pressure Washer Model UT80522G Parts)
Keep searches simple, eg. "belt" or "pump".
Lifter Stopper Plate Assembly
PartSelect #: PS9873263
Manufacturer #: 099980425049
$5.95
Special Order
Common Symptoms of models starting with UT80522
[Viewing 1 of 1]
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Must have froze over winter (stored in garage)
Repair was easy, however had to u tube issue for proper orientation of parts as it did not come with any instructions. Wished I had two as shipping was twice as much as part. Very satisfied.
Parts Used:
-
Duarte from GRISWOLD, CT
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Wrench (Adjustable)
7 of 14 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Fuel system damaged by allowing E85 gas to remain in tank.
Tank is held in place by 2 nuts and 1 bolt. These were removed and tank lifts off. Installed filter assembly and fuel hose to bottom of new fuel tank. You must install fuel hose clamp to tank connection before installing new tank. Install the other end of fuel line to carburetor on engine with other clamp and you are finished.
Parts Used:
-
Jimmy from BURLINGTON, NC
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Socket set, Wrench set
3 of 4 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Leaking hoses.
1) Loosen engine assembly from frame.
2) Remove fuel tank, hoses and disassemble other hoses and components.
3) Attach new hoses to carburetor.
4) Reassemble fuel tank, engine and carburetor components.
5) Re-center motor engine assembly onto washer frame and tighten nuts, bolts and washers as needed.
2) Remove fuel tank, hoses and disassemble other hoses and components.
3) Attach new hoses to carburetor.
4) Reassemble fuel tank, engine and carburetor components.
5) Re-center motor engine assembly onto washer frame and tighten nuts, bolts and washers as needed.
Parts Used:
-
Cheryl from BEACH PARK, IL
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Socket set, Wrench set
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!