This is a replacement dishrack roller or wheel for your dishwasher. It is made of gray plastic, measures a little over an inch in diameter, and is sold individually. This roller is designed for the lo...
$15.00
In Stock
Order within the next 1 hr and 29 mins and your part ships today!
Order within the next 1 hr and 29 mins and your part ships today!
Questions And Answers for SHEM78WH5N
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Brian
July 27, 2021
How do I install the inlet valve assembly I ordered from you? Part #00687148
For model number SHEM78WH5N
Hello Brian, Thank you for the question. The valve can be accessed from the back of the dishwasher at the bottom pan, so you will need to pull the appliance out from the counter. Make sure the power supply and water supply are turned off. The valve can be unscrewed from the water supply hose and the plastic housing can be removed. Once the plastic housing is removed it will opens in half, the valve can be replaced and the wire connector can be switched to the new valve. We hope this helps!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
This is a piece of cake. No tools are actually needed. Grasp one end of the old seal and gently pull it out of the groove in which is fits. Take the new seal, and paying attention to which way around it fits (there is a right and wrong way!) start at either end. Leave an inch or so beyond the groove to rest on the bottom of the dishwasher, and press the seal in place in the groove. You should have an inch or so left at the far end. Go back and go all along the seal and make sure it is pressed evenly and completely into the groove the full length.