RTP308-P1142505NL,K Caloric Cooktop - Overview
Sections of the RTP308-P1142505NL,K
[Viewing 3 of 3]
Keep searches simple, eg. "belt" or "pump".
Spark Electrode
PartSelect #: PS11740866
Manufacturer #: WP3185804
This part helps your burner ignite and produce flame.
No Longer Available
Spark Ignition Module with Bracket
PartSelect #: PS2034431
Manufacturer #: 32020101
This part comes with the mounting bracket.
No Longer Available
Refrigerator Screw
PartSelect #: PS11745625
Manufacturer #: WP8281227
This screw is sold individually.
$18.09
In Stock
Valve Screw
PartSelect #: PS3651486
Manufacturer #: W10491986
Part might differ in appearance, but functions same as original. Sold individually.
$9.88
Special Order
CLIP, ELECTRODE *
PartSelect #: PS2197614
Manufacturer #: Y07714200
This clip is well under an inch in diameter. It is made of metal and it will help secure a range's electrode.
No Longer Available
Common Symptoms of the RTP308-P1142505NL,K
[Viewing 3 of 3]Will Not Start
Fixed by
these parts
these parts
Show All
Gas igniter glows, but will not light
Fixed by
these parts
these parts
Show All
Element will not heat
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
2 of 4 burners wouldn't light
Unplugged the stove, removed all 4 burner discs from the stove top (2 screws each) and disconnecting electrode wires as I pulled them out, removed the stove top, unscrewed the old module, removed the 6 wires, connected wires to the new module, screwed it into place, reinstalled the top while poking the electrode wires through the top one by one, put the stove top in place, connected the wires to the burner discs. Done, and it works! It took longer to find and order the part than it did to change it out.
Parts Used:
-
John from Alexandria, VA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
25 of 29 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
There was a crack in the porcelain not letting it spark
I used a screwdriver to pry the electrode assy. out of the burner. then disconnected the wire.
Then just connected the new electrode and place the assy, in the burner.
Then just connected the new electrode and place the assy, in the burner.
Parts Used:
-
Billy from Martinsville, IN
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
23 of 36 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Spark did not ignite one burner and sometimes two
I could not figure out how to get to the igniter until I went to the "Part Select" web site and found a post that was exactly like the problem that I had. IE: Remove two screws holding each burner, Lift off top, remove old igniter being "Carefull" not to mix up the wires when putting them on the new one, installed new igniter in bracket and mounted in position, Reinstalled top and PRESTO - it worked. First post was VERY HELPFUL. Thank you
Parts Used:
-
Frederick from Eagle, WI
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
14 of 16 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!