RF267ABWP (XAA-0000) Samsung Refrigerator - Overview

Sections of the RF267ABWP

[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".
Refrigerator Evaporator Cover Grommet – Part Number: DA63-40167A
Refrigerator Evaporator Cover Grommet
PartSelect #: PS4153930
Manufacturer #: DA63-40167A
  No Longer Available
Ice Maker Assembly Kit – Part Number: DA97-05422A
Ice Maker Assembly Kit
PartSelect #: PS4173396
Manufacturer #: DA97-05422A
Ice Maker Assembly - 7 Cube
  No Longer Available

Questions And Answers for RF267ABWP

Be the first to ask our experts a question about this model!

Common Symptoms of the RF267ABWP

[Viewing 1 of 1]
Ice maker not making ice
Fixed by
these parts
Fixing
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Ice maker stopped making ice and made a repeating clicking sound
YouTube the video on how to replace the ice maker. Unplugged the fridge, one screw was removed to open a small cover panel to access where the ice maker was plugged in, unplugged the ice maker, pushed a small locking clip and pulled the old ice maker off the keyhole slots holding it in place removing it from the fridge. Did the steps in reverse and reinstalled the new one. Plugged the fridge back in and reset the fridge by holding the energy saver and alarm button on the front door simultaneously for 8-10 seconds until it beeped. Took a few seconds and the fridge reset
Parts Used:
Ice Maker Assembly Kit
  • Robert from AKRON, OH
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Not making ice. Making ice slowly. Clicking sound when making ice.
(1) Set ice production to OFF from the front panel of the refridgerator. (2) Inside the fridge, remove the screw holding the panel covering the cable for the ice naker assembly. (3) Remove the panel. (4) Disconnect the power cable of ice maker. (5) Holding the assembly with one hand, release the locking clip of assembly housing, and slide assembly forward until it is free. (6) Remove the ice maker assembly. (7) Install the new assembly by reversing the previous steps. (8) Reset the ice maker by pressing the reset button and holding it for at least 8 seconds. The first time the ice maker is primed with water, there are 2 chimes. (1 High , 1 Low).
Parts Used:
Ice Maker Assembly Kit
  • Gregory from North Richland Hills, TX
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!