This temperature sensor, also referred to as a thermistor, is a genuine replacement component compatible with various appliance models. It works in coordination with the control board to monitor inter...
This clear inner glass lets you see inside your LG oven while keeping the heat in. If your oven glass is cracked or chipped, replacing it helps restore energy efficiency and safe cooking. It’s made to...
Upgrade your oven with this durable gliding shelf rack, designed to provide a stable surface for baking, roasting, and broiling. Its smooth sliding design makes it easy to insert and remove dishes, of...
I searched online and found someone that seemed to have the exact problem. That person had replaced the lower burner and the same PCB board I replaced. I was able to test the lower burner without removing it and it tested OK. The PCB board in the article I had checked was burned and obviously bad but mine was not. I took a chance and ordered just the PCB board. I replaced this board and the oven now works perfectly. I seems this board was not turning on the bottom burner but the system thought it was working fine.
The two ribbon cables connecting the panel to the PC board slide into connectors on the PC board, these connectors have small tabs on each end that are pulled up to free the cable connection, then are pushed down to secure the new cable ends. Use a long Phillips bit on your screw gun to reach the screw at the bottom of the PC board.
Very easy.1: Shut power to stove. 2: Remove 3 hex screws from oven to range top at underside of top. 3: Raise to from front and disconnect multi- connector at right rear of top. 4: flip over top and demoed 4 screws on hold down strap at each side. 5: Remove element from under strap. 6: Disconnect element from wires./ remember where wires were connected. Connect multi connected from stove. 7: Replace strap and flip top, screw it back on, put power back on. Only about 30 minutes even if you get a coffe break. Don’t even have to move stove.
