This temperature sensor, also referred to as a thermistor, is a genuine replacement component compatible with various appliance models. It works in coordination with the control board to monitor inter...
This clear inner glass lets you see inside your LG oven while keeping the heat in. If your oven glass is cracked or chipped, replacing it helps restore energy efficiency and safe cooking. It’s made to...
This radiant surface element is a genuine OEM replacement for select LG electric ranges, designed to generate heat beneath the glass cooktop for a single burner. It ensures fast, even heating for effi...
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Christian
December 28, 2021
Oven will not heat on bake setting but will on roast and broil. Seems like an issue with the bake element.
For model number RF1032BS
Hi Christian,
Thank you for contacting us. If the bake element is not heating correctly, the issue may be with the oven temperature sensor. The oven temperature sensor is the part that monitors the oven temperature and signals the electronic control board to turn the elements on and off. Before removing this part from the oven and testing it with a multimeter for continuity, unplug the oven from the electrical outlet. To test the sensor, you will need to reference your owner’s manual to determine what the correct reading should be for your model, as this varies from model to model. To test it for continuity, use a multimeter on the Rx1 setting and touch the terminals with the probes. This test needs to be done with the sensor at room temperature to produce accurate results. If your test results do not meet the manufacturer’s guidelines, you need a replacement temperature sensor. If the sensor is fine, you will need to check the bake element, the electronic control board and the wiring between the parts to see which one is causing the issue. We hope this helps! If you have any questions, please let us know.
MY LG OVEN WILL HEAT TO ABOUT 350 BUT WILL NOT HOLS HOWEVER THE BROILER WORKS- WHAT PART DO IO NEED?
For model number RF1032BS
Hi Susan, thank you for contacting us. According to our research, we would recommend checking the following parts: thermostat, part number PS3530468, temperature sensor, part number PS11732697, and bake element, part number PS3535354. We hope this sorts out your problem!
I searched online and found someone that seemed to have the exact problem. That person had replaced the lower burner and the same PCB board I replaced. I was able to test the lower burner without removing it and it tested OK. The PCB board in the article I had checked was burned and obviously bad but mine was not. I took a chance and ordered just the PCB board. I replaced this board and the oven now works perfectly. I seems this board was not turning on the bottom burner but the system thought it was working fine.
Removed the back of the Range. Removed one wire at a time from the old PCB and placed it in position on the New PCB. Then secured the New PCB in the holder.
Very easy.1: Shut power to stove. 2: Remove 3 hex screws from oven to range top at underside of top. 3: Raise to from front and disconnect multi- connector at right rear of top. 4: flip over top and demoed 4 screws on hold down strap at each side. 5: Remove element from under strap. 6: Disconnect element from wires./ remember where wires were connected. Connect multi connected from stove. 7: Replace strap and flip top, screw it back on, put power back on. Only about 30 minutes even if you get a coffe break. Don’t even have to move stove.
