This microwave roller guide sits under the glass turntable tray and plays a key role in smooth, even rotation. If your turntable is wobbling, sticking, or not turning at all, replacing the roller guid...
When you're in need of a turntable shaft for your microwave, look no further than this GE Turntable Shaft. This little piece might not seem like much, but it's a crucial part of ensuring your microwav...
Having trouble with your GE appliance? Our authentic GE MICA COVER could be just the fix you need. This isn't just any part'it's the key to unlocking the best performance from your device. Made with...
Looking for a reliable solution to ensure your microwave works safely and efficiently again? The GE Microwave Thermostat is what you need. It plays a crucial role in preventing any overheating, which ...
This range ceramic light lens covers and protects the interior light bulb, allowing clear illumination of the cooking area while shielding the bulb from heat and debris. Made from durable, heat-resist...
Are you looking for a way to improve your cooking and bring your kitchen appliance back to its optimum performance? Our GE brand metal tray could be just what you need. This sturdy, nonstick tray is...
Turned of f the circuit breaker to the microwave. Unscrewed the cover (1 screw!) popped out the old bulbs and plugged in the new ones, using the bubblewrap as a handle to be sure my skin didn't touch the light bulbs so the oil from my hands didn't damage or shorten the life of the new bulbs. Turned the circuit back on. That's it!
This is the second time that this lamp hase gone out. It is located in a small space in the top of the microwave and you need to remove the top front pannel, then take a screw or two out of a metal shield and bend the shield up to get your hand into the compartment where, if you know how, you can reach in and lift out the reflector shield that the lighbulb is plugged into and remove the old one and plug in the new one. The first time was hard to figure out how to do it but the second time wasn't bad because I knew how to do it.
*Remove Two Phillips head screws from the top of vent slide the vent left to remove it. Take the charcoal filter out then the metal cover underneath the filter. It also has a phillips head screw. bulb socket is on right facing down. Squeeze the metal clips and remove socket from bracket. Installation is the reverse of removal.
