P4360 Ryobi Pole Saw - Overview

Models starting with P4360

Keep searches simple, eg. "belt" or "pump".
TRIGGER – Part Number: 099988002040
TRIGGER
PartSelect #: PS18782226
Manufacturer #: 099988002040
$5.95
  Special Order
SWITCH ASSEMBLY – Part Number: 099988002043
SWITCH ASSEMBLY
PartSelect #: PS18782227
Manufacturer #: 099988002043
$12.95
  Special Order
COMPRESSION SPRING – Part Number: 099988002044
COMPRESSION SPRING
PartSelect #: PS18782228
Manufacturer #: 099988002044
$5.95
  Special Order
LOCK OUT BUTTON – Part Number: 099988002045
LOCK OUT BUTTON
PartSelect #: PS18782229
Manufacturer #: 099988002045
$5.95
  Special Order
CONTACT PLATE – Part Number: 099988002046
CONTACT PLATE
PartSelect #: PS18782230
Manufacturer #: 099988002046
$5.95
  Special Order
OUTPUT SHAFT ASSEMBLY – Part Number: 099988002032
OUTPUT SHAFT ASSEMBLY
PartSelect #: PS18782219
Manufacturer #: 099988002032
$11.95
  Special Order
Seal – Part Number: 570820001
Seal
PartSelect #: PS12606430
Manufacturer #: 570820001
Rubber seal ring bar oil
$5.95
  Special Order
Screw M4 X 18 Mm, T20 Torx Pan Hd. – Part Number: 661189003
Screw M4 X 18 Mm, T20 Torx Pan Hd.
PartSelect #: PS16392161
Manufacturer #: 661189003
$5.95
  In Stock
SCREW SEMS STEEL CH, M4 X 8 SF – Part Number: 661861001
SCREW SEMS STEEL CH, M4 X 8 SF
PartSelect #: PS18788219
Manufacturer #: 661861001
$5.95
  Special Order
Saw chain p 0375 – Part Number: 310987002
Saw chain p 0375
PartSelect #: PS12620866
Manufacturer #: 310987002
$14.95
  Special Order
RUBBER PLATE – Part Number: 570115001
RUBBER PLATE
PartSelect #: PS18786826
Manufacturer #: 570115001
$5.95
  Special Order
WASHER – Part Number: 690733001
WASHER
PartSelect #: PS18788930
Manufacturer #: 690733001
$5.95
  Special Order

Common Symptoms of models starting with P4360

[Viewing 2 of 2]
Chain comes off guide bar
Fixed by
these parts
Fixing
Show All
Will Not Start
Fixed by
these parts
Fixing Fixing
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Needed added length to Ryobi pole saw to reach higher branches
This was an added to make the pole saw longer, when needed. Hand tightening is all that's required; fits perfect, without any loss of power. Makes using the saw more difficult, but beats climbing trees, or using ladders.
Parts Used:
MIDDLE POLE ASSEMBLY
  • Nobuo G. from WOODACRE, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
10 of 10 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
bar on my chain saw
it took you two and a half months to get my part to me. it took all of two minutes to install. wont order anything from you guys again. thanks for your inquiry.
Parts Used:
BAR
  • Joshua from PENSACOLA, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
5 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The chain gear was lost during work in the area. When trying to buy replacement parts Ryobi had discontinued the parts for the saw model number. Found the parts needed after spending time on the internet and comparing parts against Ryobi parts. Located the parts needed at PartSelect.com.
Cleaned the parts for the saw. Unpacked the new parts and installed the gear, washer and snap ring. Back cutting limbs and small trees.
Parts Used:
WASHER (OD25 X ID9 X 1.5T) SPROCKET RETAINING RING
  • William from YOUNGSTOWN, NY
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
3 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!