This convection fan motor assembly is designed to circulate hot air throughout the oven cavity, promoting even heat distribution for more consistent baking and roasting results. By keeping air moving ...
This high-limit thermostat (part number DE47-20037A) is for ranges. High-limit thermostat DE47-20037A trips when the oven overheats. Unplug the range or shut off the house circuit breaker for the rang...
This oven temperature sensor monitors the temperature inside the oven and sends that information to the control board, helping maintain accurate and consistent cooking temperatures. It plays an import...
This convection fan blade (part number DG67-00011B) is for ranges. Convection fan blade DG67-00011B spins on the motor shaft to circulate hot air through the oven for even heating. Unplug the range or...
This main top is for ranges. It provides a stable cooking surface and houses the surface cooking burners.
$391.12
On Order
Questions And Answers for NE58F9710WS
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Mel
March 24, 2020
Door won’t open and display black after self clean cycle. Is that a blown thermal fuse? What part do i need please and i will order it! Thanks!
For model number NE58F9710WS
Hello Mel, thank you for your question. It could be a thermal fuse which is PS4226434. If that part isn't the issue, the most likely problem would be the electronic control board. I hope this helps.
I removed the control panel with a Phillips screwdriver and unplugged the burner switch and replaced the new switch and put the control panel back in place and turned on the burner and it worked as it should.i realized that I only would have only had to remove the 4 screws on the bottom of the control panel. All I would have had to do was just take those 4 screws out and remove the switch control knob and the two screws that held the switch in. Am very happy with the results
Cool oven, open door. Turn off electrical power. I laid a cloth over door to protect and to catch ant screws that my fat fingers would drop. I removed 4 screws under control panel. I pulled panel up and off stove face. My wife held it safely as I removed the triple burner knob. I then placed new switch, on stove top in same position as old one. I then removed screws holding old knob to release from control panel. The removed electrical connections one at a time and installed on new switch. Reinstalled switch back in control panel. Reinstalled control panel. Placed knob back in place. Turned electrical power back on. Then tested burner. Wife is happy and so am I.
I took off the back cover after I looked at youtube similar problems. Then removed the little thermostat and un hooked the 2 wires. I looked up the part and after is was delivered couple days later I connected the 2 wies and after putting the back cover on the oven was back to normal. Was such an easy repair and the part was only $11.
