This is replacement vent grille or vent grill for your microwave. You will find the grill vent either above or below the microwave door, depending on your model. If your vent grill is discolored or cr...
This bracket holds the metal or plastic flapper that closes off the exhaust duct when the fan is not running and opens when the fan turns on. If the exhaust fan on your microwave does not appear to be...
This part is the replacement door handle for your microwave. It is made of white plastic and is approximately 11 inches long and 1 inch wide. The door handle attaches to the microwave door and allows ...
This charcoal filter in manufactured to fit a microwave. It removes food odors from the air circulating through your appliance vent. Youi may need to replace this part if you notice odor when cooking ...
If the turntable on your microwave does not rotate, or you can hear a grinding noise, the problem may be with the motor. The motor is typically located below the floor of the oven, and is accessed thr...
This is the replacement door handle for your microwave. It is made of black plastic and is approximately 11 inches long and 1.5 inches wide. The door handle connects to your microwave door and allows ...
Are you struggling with a faulty microwave door? Introducing the Locker Door Latch Housing Assembly, a crucial part specifically crafted for LG microwaves. This essential component guarantees that you...
$55.94
Special Order
Questions And Answers for MV2041ASD
Be the first to ask our experts a question about this model!
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Repair was easy but you have to remove the screw at the top of the microwave (top left) in order to secure the far left tab with the hole in the tab. Place the grille in place, push to the left and then secure the screw you removed. Just remember that the mounted screw will need to be removed the next time you need access in order to replace the charcoal filter.
I replaced the whole component with all three switches in it even though only one switch was bad . Taking out one switch out of the holder unit would probably have damaged the unit that was holding the switches. Easy install and it works great again .
