MTMX050EF3WW General Electric Dryer - Instructions

The door to the clothes dryer would not open without the handle. To be able to use the dryer I secured the handle in place with packaging tape. The Part Select website made it extremely easy to identify the replacement part using just the model number. I placed the order on Thursday afternoon and received the part on Friday morning. I had to twist the broken handle to remove it from the door. Then I was able to snap in the replacement handle back in place with little force. Thanks to Part Select my problem was easily rectified.

The pkg. came, I opened it and snapped the handle into the dryer hole & Wham -done!
No tools, no sweat! Could not believe how fast the door handle arrived-GREAT job!!! Will use this company again and tell my friends.
5 stars!!!!!!!

The door handle clicked into place (10 seconds).

Snap on part , order came in quickly and repair done unit good as new. .

just put new one on. no tools needed fits in holes already there. handle just snaps on,

I just snapped the door handle on the dryer in less than a minute. I am completely satified. Did I mention I received my part in one day. I ordered online before 3pm and received it the next day before 11am. Very impressed. Thanks PartSelect!!!

Snaped the new handle back on...no tools needed,
just fit the plastic groves of the handle into the holes on the dryer door. Very simple!

just 4 slots where the handle goes. Snapped handle into slots, good as new.

Very simple...just remove the inside of the door & replace.Great service on delivery of item ordered.quick!

Dryer would turn on when you pushed the "on" button, but as soon as you let go, it would turn off. Found the plastic door switch cracked (from slamming door closed). Unplugged the dryer. Unscrewed the two screws inside the top of the door to unfasten the top panel. Took the top panel off. Then unscrewed the two screws on the side to unlatch the front panel. Used plyers to take the 3 wires off the switch and slid the switch through the front of the door. Juat remember where the wires go. Then inserted new switch and connected the wires. Vacuumed out the dryer and reassembled. It took about 20 minutes and was easy! If I can do it, you can!!!

Faulty Door switch. Dryer would heat up so I knew it wasn't thermostat or element related.

It took a while to diagnose the problem. I finally figured out it was the door switch by pushing it with my finger with the dryer door open and starting the dryer. It would run like that, but the switch was not being pressed in enough by the door. I ordered the switch and I should have been able to replace in about 15 min. But the old switch broke while I was removing it and it fell back inside the unit. So I had to remove the top and the front panel to access the door switch. That's why it took so long. If that had not happened it would have been a much simpler repair.

new part arrived and had it installed and working in less than 3 minutes.

just replace the handle

its very easy!! just pull or pry out the old handle clean surface snap in the new one! its that easy!! PS don't get to rough with the installation!!