MMV4205BAS Maytag Microwave - Instructions

All I did was removed the glass revolving tray and insert the coupler. Couldn't have been any simpler and the turntable was working again. Part was received the same week it was ordered. Very quick and didn't use any gas to go out somewhere and look for the part. Very pleased!

strategically placed coupler in the hole and wallah! placed the plate back on it and watched her go around! Feel like a genius! lol

Replaced with new motor from Parts Select. Part was a correct replacement for the old one. perfect fit. Works like it did when it was new. I will recommend Parts Select to anyone. Thank you very much. I would definitely use your company again in the future. I saved $30 by not using parts from GE.

Ordered part and screwed in. Part could not be found in hardware store even though it was just a long set of screws. Agent quickly identified part with model number of microwave and it was at my home the next morning for installation. Great service!

Just placed it in. Ordered, received in less than a week and it was working in minutes after being broken for 6 months Thank you!!!!!!!!!!!!!!!!!

itt slipped right in, works great. thanks so much. If not for the reviews and no picture of the part, I would not have known what to order. thanks again

Took the broken coupling out and put the new coupling in

After contacting parts select they assisted me in ordering the correct replacement part. The folks I talked to on the phone WERE EXCELLENT in working with me to fix the issue. I has ordered a coupler that dammaged after a week of use and they replaced immediately telling me I had a year warranty! Great Company and Thank you it is working perfectly.

Very easy. Opened the Microwave door, removed the dish and replaced the coupler.

Snapped the coupler in place. Took one minute.

Asked at Best Buy what our options were after I described the problem. They said to buy a new Microwave. I thought No way it is only a few years old. Whent home did som research and found your site and for under $5.00 My microwave turn table turns again!

Removed old coupler with my fingers and installed new one on shaft. Works fine.

Try to turn Coupler. If it is loose it is broken 1. pull old one out 2. line up keyway on new one and press it in. (If mild resistance was felt while turning coupler it is not coupler most likely drive motor)

replace filter according instruction

Not so sure this would qualify as "instructions", but I only needed a screwdriver because the "D" rings of the old vent filters broke off and I had to pry to old ones out. Keep in mind, I am mechanically disadvantaged and can barely change an A/C filter ... that being said, all I did for this order was input my Model number and PartSelect found the correct replacement part. I receive the parts super quick (faster than the other 2 purchases I did that day). The only bummer was the packaging ... super huge box for small tiny parts. Otherwise, I now know where to go for replacement parts. This project should be a "no-brainer" for most DYI's, so getting the right parts with just a model number was lifesaving for me :0)