MDB662RCS0 Frigidaire Dishwasher - Instructions

Rollers just snapped on the diswasher rack. Took just seconds to do.

This is a case of weak OEM design. Substantial (cup) weight placed on the rack will ultimately cause these wheels to break under load stress. My fix went slightly beyond the design by installing 8 cents worth of washers between the wheel and the screw head. That way any slack was reduced so that the wheels were less stressed at an angle. The rack now sits square and the wheels more true than design. I picked up some lock washers at local hardware store and flattened them out to fit smooth. The parts supplied by PartSelect were perfect fits to OEM. This is a truly easy repair. If your top rack keeps falling off the guides due to broken tub wheels this will take care of the problem. I will add that the parts that you can obtain through PartSelect are adequate without improvising. I just went for a more robust fix to the original design with additional washers. Hope this is helpful.

power off, take off kickplate, unplug 2 wires and unscrew broken nuts, put new nuts on, plug wires back in,(run dishwasher one cycle to make sure no leaks) put kickplate back on, power on.

Ditto the other comments. Easy, great savings. Perfect. Thank you!

Just a littlr snap in the right place and perfection!

Pulled the old gasket ou, cleaned the groove with a cloth. Then pushed the new one in, starting at the bottom. The curvatures are clearly marked, no guesswork.

Nothing to it. Just inserted the iron stud into the center wheel and pressed the bracket onto the stud.

Spotted the source of the leak at the first heating element under the dishwasher. Removed the brass mounting nut and it was cracked. Replaced with new part from PartSelect.com and the leak was fixed. Apparently the heating element gets so hot it tends to crack the mounting nuts, which results in a leak. Delivery time for part said 3-5 days - mine arrived one day after ordered!

Got the parts in a DAY! Wheels were broken and worn causing top tray to slip off runners- new wheels were easy to put in-used the screwsfrom the old ones and banged out the job in about 20 minutes, including letting my son help. Thanks Partselect, you've hooked a new DIY'er (my son)

Ordered the new roller assembly and in no time the upper rack was back together, up and running. Now to see about replacing the other two rollers and the side rails as they are showing wear and tear.

Thanks for the quick ship.

Removed lower panel; unmounted fill valve assembly. Installed two springs. Remounted fill valve assembly and reinstaslled the lower panel. Door must be in a near closed position to gain access to the door "L" spring brackets.

Simply remove the bottom panel below the door. The owners manual (22 year old model) showed the proper hole in which to attach the spring. Attach spring to door and then to frame of dishwasher, as illustrated in manual. It is a tight fit to get your hands in there, but once you do it is a snap. We have replace these springs several times over the life of this appliance, this is the first time we have actually found the proper springs, should last a long time. Thank you Parts Select for having the inventory for such an old model!

I only had one break, but bought both to replace. I don't agree with those that say you have to slide the dishwasher out to repair. I simply removed the lower kick plate, and replace the springs in no time. Very easy as was ordering the parts. I will return here for all my appliance parts in the future. Hope I don't actually need any.

I removed the 2 screws that hold the dishwasher in place. Slide out the unit just far enough to access the brass nuts on the heating element. Pulled off the wire, and replaced the broken nut with the new nut. Replaced the wire, slide the unit back into place and reattached the 2 under counter screws. Done!!!

2 wheels were missing and I replaced them in 2 seconds. The diagram online was a huge help!