LVM1750DP1BB General Electric Microwave - Instructions

Unscrewed 2 screws on the top panel where's the panel left hold it out the filter was sitting right in front of me replace filter put screws in job is done

I just inserted the new holder inside the opening.

remove two screws bend out flaps remove broken glass install new glas bend flaps back to hold glass install two screws. Done.

Removed the control panel, one screw at the top. Removed 2 screws on the door switch holder and removed the door switch. VERY EASY.

thank you for the video--very clear, responsible, applicable although the illustration was not exactly of our kind of light. the bulb was exactly like the one Hotpoint used in its microwave made in 1989! I will come back to you for parts in the future. (You have the model # from my original order.)

After I somewhat diagnosed the problem, a faulty control pad, I researched a source for a new control pad with a reasonable price. That was Partselect.com. The part was new, in stock and a good price. I had several delivery options, I chose standard delivery of 5-7 days. It arrived in 5. I removed the old panel in about 10 minutes and carefully installed the new pad. Turned on and it works fantastically.

Unscrewed broken handle and removed it... once new handle arrived screwed it on.

This repair was easy and could be done by anyone. If you undertake to do this replacement, remember to slowly bend the medal tabs back that hold the lens. Handled roughly these tabs could break off.

This repair can be don in under 5 minutes, easily !!

Last week I removed the glass cover that was held in by one screw and removed the burnt out light bulb. I ordered the bulb and left the glass cover off until the bulb arrived. I had to wait until this evening to put the glass cover back on and fasten the screw because I have a window right next to the oven and the sun streaming in made it too difficult for me to see how to put the glass back in and replace the screw.

Remove and replace by unscrewing. Ribbon cable disassembly is by lifting a release tab on the socket on the board and reverse when reinstalling. Remove power as electrical parts are exposed.

Replaced glass in frame and replaced lights

pluged wires back on ,placed lamp holder and bulb back and replaced screws

Tyring to get bulb out i ruined the light socket. Unscrewed the bottom cover of microware. Took out screw holding light socket, removed wires to socket with pliers, intsalled new socket. It was a piece of cake and the part was a perfect match.

Removed difuser (one screw), removed old bulb, screwed in new bulb, replaced difuser.

Screwed in new bulb.