This handle screw, also known as a mounting bolt, is a mounting screw to help secure the door handle to your refrigerator door. If your handle is loose, you may just need to tighten the screw. If your...
This is a single water filter that can be accessible inside the refrigerator. Water filters are designed to provide cleaner and betting tasting water, while also protecting refrigerators and ice machi...
This part is the replacement ice tray for your refrigerator. The tray is made of white plastic and is approximately 9 inches in length, and 3 inches in width. It has the capacity for 8 ice cubes. The ...
Is your LG Refrigerators ice dispenser giving you trouble? It could be that the Dispenser Ice Chute Door DC Motor needs a replacement. This motor is an important gadget that allows the ice door on you...
Meet the LG Lower Door Hinge Assembly: your perfect solution for a smoothly functioning fridge door. This is a genuine OEM product, conceived and made by LG itself, so you can be fully confident of it...
Having trouble with your LG refrigerator? The Defrost Sensor Assembly is here to help. This essential part keeps track of the temperature inside your fridge, ensuring your food stays as fresh as possi...
$66.11
In Stock
Questions And Answers for LSC27921SW
Be the first to ask our experts a question about this model!
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
To replace the warped tray, I found the service manual (pg. 124 below) which took some interpreting. Removed the lever. Then removed the assembly by two screws that are forward to the unit and go upwards. The insulation, sensor, and sensor cover are simply pulled down and off and the unit separated to removed the tray, and then insert the new tray. Proceed in reverse. Takes only a few minutes.
First ,I unplug the refrigerator . 2nd i remove the back cover, clean the dust. 3th disconnect the water line, remove the all valve.. 4th unplug all the wires and code ea with a No,remove the water lines 5th replace the valve reconnect the wires and water lines.replace the back cover at last screw back the water line.check for water leaks . i found ease the valve replacement installation. .Thanks for the video.
Removed ice dispenser and display with small screwdriver from front of the fridge. Pried out the whole piece slowly. This exposed the motor that activates the chute. Plugged in the new motor before any removal to verify the motor was the problem. When it worked, removed old and installed new. 3 screws. Piece of cake.
