This temperature sensor, also referred to as a thermistor, is a genuine replacement component compatible with various appliance models. It works in coordination with the control board to monitor inter...
Is your oven struggling to reach the right temperature for your baking needs? The problem could lie with the Heater Sheath, a critical component located at the base of your oven. Responsible for gener...
This clear inner glass lets you see inside your LG oven while keeping the heat in. If your oven glass is cracked or chipped, replacing it helps restore energy efficiency and safe cooking. It’s made to...
Your LG range is crucial to your daily cooking, and it deserves nothing but the best replacement parts. Enter the OEM Radiant Surface Element. Directly crafted by LG, this finest quality part boosts y...
Upgrade your oven with this durable gliding shelf rack, designed to provide a stable surface for baking, roasting, and broiling. Its smooth sliding design makes it easy to insert and remove dishes, of...
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
James
January 24, 2025
Model # has /01 on it. Stove takes 1 hour to get to 375. Is there a diagnostic guide to figure out what is not working properly?
For model number LRE30757ST
Hello James, thank you for your question. Most times it is the Temperature Sensor PS11732697 that need to be replaced. We hope this helps.
Verified P/N with LG. Took a few days . They sent names of several suppliers, cost was almost double. Ordered part from P/S, here in 2 days. Watched video on you tube. Unplugged, took off back, unplugged bake element, removed power box. The opening for bake element is still attached to rear panel by tiny bits of sheet metal. Used Dremel with cut-off wheel to cut thru nibs & deburr opening. this panel has to be removed, it rests on bottom panel & is held in position by power box. Removed bake element carefully, front of element broken, tried to put new element in, would not fit. Had to grind notches in bottom panel down to clear supports on new element. This did the trick. back together quick & no problems. If had to do again estimate less than 1 hour.. By the way am 81 yrs. young.
Unscrewed the back panel and Sub assembly then unplugged the board and replugged and put back screws. The ribbon wires were kinda hard to put back in make sure they are in all the way. Check the therm fuse first ( $3.00 fix ) mine was good so next was to try the board.
