This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. The run capacitor is attached to the compressor. This part is 120 volts a...
$66.01
In Stock
Order within the next 7 hrs and your part ships today!
This bin can be moved according to space needed. It holds items on the door of your refrigerator. They are sometimes called Cantilever Shelves as they are supported by the back of the shelf itself t...
$84.91
In Stock
Order within the next 7 hrs and your part ships today!
This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.
$119.06
In Stock
Order within the next 7 hrs and your part ships today!
Sold individually.
This is a genuine part. The handle mounting shoulder screw (no.10 ab) is made for use with many refrigerators. The metal screw helps to fasten the handle assembly to the outer do...
$27.52
In Stock
Order within the next 7 hrs and your part ships today!
Order within the next 7 hrs and your part ships today!
Questions And Answers for LFFH21F7HWG
Ask our experts a question about this model and we'll get back to you as soon as possible!
6 questions answered by our experts.
< Prev
1
2
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Benjamin Taylor
November 7, 2019
The unit will not start change the grey box on side of compression and nothing wrong
The relay
For model number LFFH21F7HWG
Hello Benjamin, thank you for your question. We would recommend replacing the Run Capacitor - 120V Part Number: 297286803, and Compressor Start Relay Part Number: 216954218 to fix this issue. I hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Aaron
January 5, 2020
My upright freezer has been acting up lately. It would blink and click when you open the door. On the display now, the power loss and door ajar light are on with no temp reading on the control.
For model number LFFH21F7HWG
Hi Aaron,
Thank you for your question. Try unplugging the freezer to see if this resets it. If after plugging it back in the lights are still blinking, you will need to replace the electronic control board. The part number listed under your model number for the electronic board is PS12364239. We hope this helps. Thank you and have a great day!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Danielle
July 22, 2021
The alarm reset light is on and it keeps beeping
For model number LFFH21F7HWG
Hi Danielle,
Thank you for your question. If the alarm reset button keeps beeping, you may have either a high temperature inside or the door is ajar. If the door is open the door ajar icon will be lit. If the temperature is high, the high temperature light will be lit. If the door is closed and the temperature is fine, you may be able to reset the freezer by unplugging it for 30 seconds. We hope this helps! If you have any questions, please let us know.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Chris
March 2, 2023
This morning temperature was at 31 degrees. Blower was running making loud humming sound. Door said power loss. Unplugged it. Plugged back in. Blower would not come back on and the power loss went off. Freezer went down to 27 degrees. Will not get any colder. Been about 6 hours. Pushed Extreme Freeze button. Fan did not come on. Did not get below 27 degrees.
For model number LFFH21F7HWG
Hello Chris, thank you for your question. According to our research, you may need to check the following parts: start relay, part number PS2331305, thermostat, part number PS2350702, capacitor, part number PS3495561, and thermistor, part number PS977306. If the issue persists, you may need to replace the control board, part number PS12364239. Good luck with your repair!
Door Ajar light on, alarm sounds, will clear when silenced, comes back on, however there's zero issues with the seal (looked at by a repair person). I cannot find a reset button, runs great. Don't want to part with it, purchased in 2010.
For model number LFFH21F7HWG
Hi Christine, thank you for reaching out. The door ajar alarm feature provides a warning if the door is open for more than five minutes. We would recommend closing the door properly and reset the unit by turning it off and turn it on back after 60 seconds. If the issue persists, you may need to replace the control board, part number PS12364239, to fix the issue. We hope this solves your problem!
This freezer has many screws that hold the cover on the back of the door and assist clamping the edge of the gasket in place. Be sure to just loosen the screws 3/4 the way out, use a flat head screw driver to pry the cover from the door in case over time it is stuck to the door. The new gasket will come in a creative box trying not to kink the gasket itself, but there will be some distortion of the gasket when you get it. Put it in the sun or in hot water. I put it in my dryer for 10 minutes. Remove the old gasket, and start at the top of the door to replace the gasket. TIPS: If the screws are backed out enough, there should not be any problem sliding the back part of the gasket under the cover. When on the sides, do not pull the gasket down to make it easier to slide the gasket underneath the cover. This will distort and lengthen the gasket so it will not fit and thin it out so it will not function well. Once the gasket is in place, tighten the screws being sure to feel along the outside edge of the gasket for any bulging that would indicate that portion of the gasket is NOT under the cover properly.
I accidently threw away both freezer keys to our upright Gibson and G.E. Freezers!!!! I had no luck finding replacements locally, so I got on the internet and came across PartSelect.com. I called them on the telephone; and after giving the model numbers of my freezers, the keys were on their way!! I received the keys very quickly and both worked perfectly. I would highly recommend Partselect.com. Charlotte M. Bishop
The repair was as easy as removing three phillip head screws for each slide rail and removing and replacing the broken slide rail. However, over the years, the walls of the freezer had bowed making the drawer a bit short to ride on the new rails -- causing the drawer to fall off the slide rails since the span between each rail was now wider than the basket. To remedy this problem. I used washers and placed them on the back side of each rail where the screws are located . This was the perfect solution compensating for the extra width resulting from the slightly bowed walls in the freezer. This solution allowed the basket to fit on each slide rail without falling off .
