LDS5811BB (ABPEEUS) LG Dishwasher - Instructions

The connector assembly connects to a spring to hold the door from falling down. You need to disconnect the power cord, the water line and the drain hose before you move the dishwasher out the kitchen counter. There are several screws that hols the dishwasher in place top, side and bottom. Removed all screws then pull the dishwasher out very slow. Take the side panel by un-screwing all the screws around the panel in my case where five screws (two in the front so you have to open the door to get to them). You need to keep the door down to connect the assembly to the door bracket and the go through the pulley then to the spring, very easy. Put the side panel back and push the dishwasher in place use the same screws and reconnect the hose the water line and the power and you are done.

pulled the dishwasher out, removed the side panel. It was very easy to replace the connector once the dishwasher was out and the side panel was removed. There are about five screws to remove the side panel. I replaced the unbroken connector on the other side since I had the dishwasher out.

Check the motor and discovered roughness when you turned the shaft. I assume there was a bearing problem. I ordered a new motor from part select and upon the replacement washer is working great! Thanks part select, my part arrived in a timely manner and you guys saved me approx. $500. Thanx again. Richard Sansom

Replaced filter assembly, mesh, check valve and impeller. Root cause was tears in almost all the fine mesh filters on the filter assy. 30 minutes. caution: impeller screw is left hand thread. This "top of the line" unit, although quiet and very good at cleaning, has had leaks, needed a new motor and this last repair. I've been able to do all the repairs and avoid expensive service calls as all the problems started to happen shortly after the warranty was up.