This temperature sensor, also referred to as a thermistor, is a genuine replacement component compatible with various appliance models. It works in coordination with the control board to monitor inter...
$59.35
In Stock
Order within the next 8 hrs and your part ships today!
This gas range oven igniter is compatible with various models of LG gas ranges. It is made up of the igniter element, wire harness, connector and mounting bracket. The igniter is responsible for gener...
$317.43
In Stock
Order within the next 8 hrs and your part ships today!
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Carissa
December 12, 2023
Hi! I’ve been having an F9 code show up on my range occasionally, but it can usually be overcome by just starting the oven again. Yesterday I had to restart it twice and we are starting to notice that cook times are not always reliable.
The oven is igniting (bake and broil each ignite their parts when activated), and eventually gets to temperature, but perhaps more slowly than it should.
Possibly unrelated, but the bottom oven is supposed to have convection, and just a bit before we started having the F9 error, we noticed we couldn’t activate the convection.
I do t really want to replace the oven yet, but feel like F9 has a lot of possible causes and would like to narrow it down before attempting to purchase parts. Do you have any advice on other troubleshooting steps I could take to figure out what my issue is so I don’t buy parts I don’t need? Without guidance, I feel like I could be jumping down a rabbit hole and might be better off replacing it.
For model number LDG3036ST
Hello Carissa, Thank you for your inquiry. The F9 error code means that the oven failed at exceeding 150 degrees Fahrenheit after 5 minutes. We would recommend checking the temperature sensor, the convection fan motor for the lower oven, the fan motor for the upper oven, and the control board. You can test the fan motors and sensor with a multimeter and check the board for any loose connections or visible damage. If you are unfamiliar with how a multimeter functions, we have videos available to assist you. Good luck with your repair.
Took off the oven door then took out the racks and two screws in the oven bottom and removed it . Then removed the heat deflector. Then un plugged the old igniter and removed the burner to make it easier to remove the old igniter. Then installed the new igniter and reversed the process
Remove oven bottoms Removed burners Remove igniters Pull out oven removed back disconnect wiring Installed new parts on burner made wiring hook ups Installed oven back and oven bottoms Tested and both work Took so long because I’m 75 years old Thanks for the proper parts
As soon as my husband put it in the oven, the very thin prongs broke. There was no guard on either side of the prongs for protection like the one that had been in there. Very costly to us of $185 with no fix. Very disappointed in that ignitor. It would have been an easy fix. Had replaced one previously but it only lasted 6 months. Now we have a new stove
