Models > KUDA22SWWH2 > Instructions

KUDA22SWWH2 KitchenAid Dishwasher - Instructions

All Instructions for the KUDA22SWWH2
121 - 135 of 176
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Rubber water tube that delivers water to the upper rack had a large hole.
Took the tube off and noted that there was a factory drilled hole on the underside that lets water drain. I slipped the new tube over the inlet port and the other end over the rotating washing arm aparatus port and everything worked fine. Very easy and fast repair.
Parts Used:
Rubber Water Delivery Tube
  • David from Shelbyville, IN
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Replace 2 Wheels
One of the axles broke off, requiring no removal. The other wheel broke off, but the axle remained. That required squeezing (pliers) to push out. Replacement was easy; just put wheel onto axle and push axle through mounting space. Total: 5 minute job.
Parts Used:
Dishwasher Single Roller Wheel Single Lower Roller Axle
  • Robert from East Brunswick, NJ
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The old tube was worn out and had holes
Took the old one off then used canola oil to put on the inside of the tube and it went on easy.
Parts Used:
Rubber Water Delivery Tube
  • Barbara from Santa Rosa Beach, FL
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Rollers and axels were worn out.
Very easily!! I am 19 years old and repaired the dishwasher for my grandmother in about 15 minutes. Great products.
Parts Used:
Dishwasher Single Roller Wheel Single Lower Roller Axle
  • Shirley from Tucson, AZ
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Rubber Hose Had Holes In Itt
I heated both ends of rubber hose and applied a small amount of vaseline inside of tube and it slid on real easy. It took less than 5 minutes to finish the task.
Parts Used:
Rubber Water Delivery Tube
  • anne from clinton, MS
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
not cleaning well
I placed the hose on one side after placing one end in boiling water. I placed the other end in the hot water and pushed it on.
Parts Used:
Rubber Water Delivery Tube
  • MORTON from WOODBURY, NY
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
0 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Water delivery tube disintegrated due to age
Removed the old tube with the aid of a knife to cut one end off the fitting. Then I lubed each end of the tube with dish washing soap and slipped them on. Done in 10 minutes. Easier to do if the top rack is removed for better access to the hose connections.
Parts Used:
Rubber Water Delivery Tube
  • LESLIE from SOUTH CHARLESTON, WV
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
0 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The rubber water tube was worn out and the water was spraying everywhere inside the dishwasher
All I had to do was remove the damaged hose and replace it with the new hose. It took all of 5 minutes. The dishwasher is working like new!
Parts Used:
Rubber Water Delivery Tube
  • Barbara from Downers Grove, IL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
0 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
old tube rotted away, top rack was no cleaning
took old tube of and heaten new tube to soften it. put some plumber grease on ends and slipped it on. longest time was boiling the water.
Parts Used:
Rubber Water Delivery Tube
  • Francis H. from New Brighton, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
0 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
broken roller weels on bottom dish rack
I simply removed the broken wheel brackets and snapped new ones on. then the wheel just sliped on. It took some good hand strength.
Parts Used:
Dishwasher Single Roller Wheel Single Lower Roller Axle
  • robert from coumbus, OH
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
0 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
water not going into dishwasher
While replacing the water valve I broke the float switch. Ordered the switch....it was here in 2 days. Great service! Will use this company again....I hope not all that much. lol
I am a retired Sears service tech, but not a dishwaher tech.
Love Parts Select!
Thanks guys,
Doug
Parts Used:
Float Switch
  • douglas from stocholm, NJ
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Pliers, Socket set, Wrench set
1 of 7 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Detergent dispenser failed to open
Removed the door cover and replaced the bi-metal.
Parts Used:
Detergent Dispenser Actuator
  • Mark from Norman, OK
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
5 of 22 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Old float stem had fine thread new one had corse and did not supply nut so had to use old one over.
put new switch and new gasket on old float stem with old nut. but it still overflows about 1/2 cup of water through stem
Parts Used:
Float Stem Kit Dishwasher Gasket Float Switch Dishwasher Float
  • Daniel from Duxbury, MA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers, Wrench (Adjustable)
10 of 39 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Water did not leave dishwasher it also leaked on floor
Went very well. The repair tech had to pull out dishwasher, check for a clog drained the water out of dishwasher by pumping into a container. All good, not sure why it did not drain for me. Repair tech got it working. I am happy.
Parts Used:
Rubber Water Delivery Tube
  • Sandi from Farmingville, NY
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
Was this instruction helpful to you?
Thank you for voting!
bottom tray had come off
I took off all the old axils and put new ones on,and then I slide the wheels on and That was all is to it. EASY!!
Parts Used:
Dishwasher Single Roller Wheel Single Lower Roller Axle
  • BILL from LANCASTER, SC
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the KUDA22SWWH2
121 - 135 of 176
Back to Top