This set of two electronic control boards contains both the emitter and the receiver. These boards tells the icemaker when it's full and that it has to dump the ice, and it also tells the icemaker whe...
If your refrigerator or freezer is too warm, or making noises, you may need to replace the fan blade. The fan blade attaches to the evaporator motor, which is in the freezer section, to help circulate...
This part is a replacement flipper or emitter cover for your refrigerator. It is made of white plastic and is approximately 3 inches by 2 inches. The flipper shields the emitter control board and hous...
This is the replacement ice maker cover bracket for your refrigerator. It is made of white plastic and is approximately 5 inches wide and 2 inches long. The ice maker cover bracket holds and supports ...
This part is a replacement refrigerator drive shaft seal for your refrigerator. The drive shaft seal protects the auger motor from water and condensation that may leak down the drive shaft from the ic...
$18.59
In Stock
Questions And Answers for KBSD608ESS01
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Donald
September 14, 2022
Refrigerator temp. is showing 66 degrees try using controls to adjust the temperature down it does not work. Freezer is working ok all items are frozen. Over temp light is flashing, alarm doen't work. I activated the max temp button to see if this will cause the fresh food section to cool down. This unit is a new home install 2019.
For model number KBSD608ESS01
Hello Donald, thank you for your question. We have researched your model and found that the issue is probably with the Evaporator Fan Blade, part number PS11738973. If that does not take care of the issue, then the problem is most likely to be related to the Thermistor, part number PS11739132. If you require assistance to place an order, please contact customer service. We hope that helps!
ALL LED LIGHTS ON TOP AND SIDES ARE BARELY SEEABLE-DIM
For model number KBSD608ESS01
Hi Gary, thank you for reaching out. We have researched the model and would recommend checking the LED Lights, part number PS16218086, for continuity. All the lights are connected in series, so a fault in any one of them can cause all of them to either go dim or stop functioning completely. We would also recommend checking the Refrigerator Door Switch, part number PS12728638, and the Freezer Door Switch, part number PS16218024. We hope this helps!
First I shut the water off to the refrigerator.then i pushed the big button in the middle of the grille below the refrigerator door. pulled out the old filter, took the front cap off the old filter put it on the new filter. took the two red caps off the new filter. pushed the filter in till it locked in place. all done! Turned the back on.
First, I tested the ice maker "switch" that actually just covers the beam that regulates the ice maker. In the "off" position, it still made ice. Then, I removed the three screws on the cover over the transmitter and disconnected the circuit board at the wire connector. It stopped. After ordering and receiving the new transmitter and receiver boards, I replaced both boards. They are located on either side of the freezer compartment under panels held in place by three screws. Probably saved 150 to 200 bucks.