JJW8630DDB Wall Oven - Instructions

first of all i was shocked at the fast delivery,two days .i just followed the instructions the other guys wrote,the only thing i might add is that the screws on the bottom of the door hinge are very tight you must have a good bit and line them up well, at first i did not think they would work but they did also you must replace the bracket as well as the hinge

1. I took the door off its hinges.2. I took the screws out of the outside of the door in order to access the nuts on the handle. Removed the nuts and a heat shield held in place by the handle nuts. 3 installing the door- you will find to tabs on the bottom glass- the tabs are fixed at the top but not at the bottom- place the tabs in the square openings and slide the glass down so that the tabs are wedged on the door- align the handle bolts through the new glass and through the inner door- replace the het shield and use the washer and nut to fasten everything together. Put the door back together

Found parts on-line from Partselect and made the repairs very easily. The oven door now closes all the way, the oven light shuts off and the oven gets hotter quicker.

The feedback from other customers was excellent. It does come apart in layers, and it helped me to number each layer with a sticky note as I dismantled it. I also kept the screws for each layer right next to the layer, so that I knew how many screws each layer used. The only thing I can add is that the tabs to remove the innermost glass from the frame are on one of the shorter sides of the rectangular frame. The tabs are part of the frame, and when you bend them outward the side of the frame detaches and you can replace the glass easily. In addition to the #1 Philips screwdriver, all I needed was a pair of pliers to bend the tabs.

Easy just loosened screws took apart door, removed broken glass and installed new glass.It took longer to clean the stove! Lol!

First I took the door off and outside to dump the glass in the trash which I had some Kevlar gloves so not to get cut. Removed the three screws on the bottom trim piece and the two on the sides remove the outside face glass next remove the four screws that hold the next glass. This glass is in a frame there is bent tab on one corner unbend open frame and install inner glass close frame rebend tab and reinstall all the parts.