JGP975SEK1SD General Electric Range - Instructions

remove old burner, put new in place

Pull range away from back wall. Remove panel behind control knobs by removing the screws that hold it on. Find hot burner light that holds lens. Remove broken part of lens. Insert new lens into hole on front of control panel and into hot burner light receptacle. Replace back panel. Slide range back into place.

I had to drill the hole to a larger size to enable the foot to fit.

took burner off installed new one thank you for fast shipping

Nothing technical.

The selector knob came as the original that fit execly easy.

Used scribe to remove grate foot plug still in grate inserted new foot.

I had to convert unit to propane and it was new out of the box. Could not remove one orifice because it had been installed too tight so I called ge for service as a warantee call we were on the phone with ge customer service for well over an hour and were transferred about 5 times all resulting in dropped calls. So, I contacted parts select and of course, paid for the part myself just get it done. It was easier that trying to work with ge. Received the part and and completed the conversion without difficulty. Along with the range top, we completely outfitted our remodeled kitchen with profile appliances including 2 ovens, dishwasher, refrigerator and a trash compactor. However, parts select was great.

Start by removing all screws 3 for each burner total of 15 t-15 bit is required then proceed to remove spark igniters 5 total slight pull next step would be to slide a screwdriver under top left and right side to remove top shelf. There you will have access to the parts you need to replace. When done just reverse installation instructions to complete

First remove the screws around the inside perimeter of the door. These require a special hex driver. Take off the inside plastic liner of door.
Peal off the old Insulation Foam Strip and replace it with the new strip in the same location. Make sure the wires are off to the right side. Replace the door plastic liner. Done. The Insulation Foam Strip really acts more like a loose gasket to keep spashing from creeping under the door and drippin out on the floor.

Could not have been simpler. Burner head dropped into place and was held in place by gravity. Not possible for part to go in incorrectly.

Ordered by phone parts & very pleased with all of transaction.

This was and always will be an easy fix, all I have to do is get my ice pick and pick the broken rubber part stuck in the hole if it does not break clean and fall out. Not much more I can say about this simple problem.

put it in but it keeps falling out. they're made narrower than my oven grate.

Replaced old burner element with new, easy