JGHC56GEJ3 General Electric Range - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Oven would not light
Removed old ignighter and replaced it with the new one. No brainier. Took longer to find the correct part, mine had three wires, most are just two.
Parts Used:
-
christine from new york, NY
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Only one and a half burners worked.
I just had to lift the top of the stove. Then pull the old burners out and put the new ones. It took longer to ignite the flame than replace the burner. Works great !!!
Parts Used:
-
Randy from Winter, WI
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
old knob broke
-
charles from brick, NJ
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
The knob that turns on the gas fire broke so I ordered a new one.
I really didn't have a clue as to where to get one so I just went without a knob not using the burner for about a year. Then I decided to call a handyman. He said the part would cost $20 and labor would be $50. I said forget it. I immediately got on my iPad and researched. I found the exact part! It came in less than 30 hours of ordering it. Then I opened the plastic bag with the knob in it, and it fit exactly right into place. And Voila! I could finally use that burner again. It was so easy to Install, no,tools necessary. It fit right into place ! I should have done that earlier had I known it would be so easy!
Parts Used:
-
Aurora L from Sacramento, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!