Models > GLEQ2152ES1

GLEQ2152ES1 Frigidaire Dryer - Overview

Sections of the GLEQ2152ES1

[Viewing 7 of 7]

Manuals & Care Guides for GLEQ2152ES1

Click to download
Keep searches simple, eg. "belt" or "pump".
Rear Drum Bearing Kit – Part Number: 5303281153
Rear Drum Bearing Kit
★★★★★
★★★★★
(65)
PartSelect #: PS459829
Manufacturer #: 5303281153
This kit includes one bearing, one ball shaft, one ball bearing, one ball bearing retainer, a small tube of high temperature lubricant, and installation screws.
$79.28
  In Stock
Order within the next 11 hrs and your part ships today!
Drum Belt – Part Number: 134503600
Drum Belt
★★★★★
★★★★★
(26)
PartSelect #: PS1148434
Manufacturer #: 134503600
This 88 3/4 inches long and 1/4 inch wide dryer drum belt goes around the dryer drum and the pulley to rotate the drum once the motor is activated.
$22.44
  In Stock
Order within the next 11 hrs and your part ships today!
Heating Element Assembly – Part Number: 131553900
Heating Element Assembly
★★★★★
★★★★★
(32)
PartSelect #: PS418120
Manufacturer #: 131553900
This dryer heating and housing assembly has terminals at four o'clock. This E-line assembly comes with a felt strip and insulators already attached.
$216.14
  In Stock
Order within the next 11 hrs and your part ships today!
Drum Support Bearing – Part Number: 131825900
Drum Support Bearing
★★★★★
★★★★★
(7)
PartSelect #: PS418807
Manufacturer #: 131825900
This part attaches onto the inside of the rear panel of the cabinet.
$8.04
  In Stock
Order within the next 11 hrs and your part ships today!
Drum Glide - White – Part Number: 137513300
Drum Glide - White
★★★★★
★★★★★
(3)
PartSelect #: PS5574052
Manufacturer #: 137513300
Appliance requires 2 .Sold individually.
$44.93
  In Stock
Order within the next 11 hrs and your part ships today!
Thermal Limiter - Limit 220 – Part Number: 134120900
Thermal Limiter - Limit 220
★★★★★
★★★★★
(11)
PartSelect #: PS419402
Manufacturer #: 134120900
This thermal fuse limiter, with a limit of 220 degrees Fahrenheit, is manufactured for both gas and electric clothes dryers. Once the internal temperature of the dryer reaches 220 degrees, the heating element cuts out.
$34.56
  In Stock
Order within the next 11 hrs and your part ships today!
Lower Front Felt Seal with Adhesive – Part Number: 5303937183
Lower Front Felt Seal with Adhesive
★★★★★
★★★★★
(9)
PartSelect #: PS832645
Manufacturer #: 5303937183
$32.29
  In Stock
Order within the next 11 hrs and your part ships today!
Door Catch – Part Number: 131658800
Door Catch
★★★★★
★★★★★
(4)
PartSelect #: PS418433
Manufacturer #: 131658800
This part helps keep the door closed while the machine is running.
$79.66
  In Stock
Order within the next 11 hrs and your part ships today!
Lint Filter – Part Number: 131450300
Lint Filter
★★★★★
★★★★★
(4)
PartSelect #: PS417841
Manufacturer #: 131450300
This white dryer lint filter screen collects lint as it passes through the dryer vent.
$36.24
  In Stock
Order within the next 11 hrs and your part ships today!
Door Strike – Part Number: 5303207102
Door Strike
★★★★★
★★★★★
(6)
PartSelect #: PS455020
Manufacturer #: 5303207102
"Male" piece of a dryer door closing mechanism.
$23.90
  In Stock
Order within the next 11 hrs and your part ships today!
High Limit Thermostat – Part Number: 3204267
High Limit Thermostat
★★★★★
★★★★★
(2)
PartSelect #: PS446428
Manufacturer #: 3204267
This high limit thermostat has a limit of 260 degrees Fahrenheit. Meaning that it will cut out when the internal dryer temperature reaches 260. This thermostat cuts back in when the temperature drops ...
$119.16
  In Stock
Order within the next 11 hrs and your part ships today!
Blower Housing with Blower Wheel – Part Number: 131775600
Blower Housing with Blower Wheel
★★★★★
★★★★★
(10)
PartSelect #: PS418726
Manufacturer #: 131775600
***Please Note: This part is a substituted part by the manufacturer. It may appear different, but should still work with your appliance.
$161.95
  In Stock
Order within the next 11 hrs and your part ships today!

Questions And Answers for GLEQ2152ES1

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

4 questions answered by our experts.
  • 1
Sort by:
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Rhonda
January 13, 2020
I start the dryer, it works briefly then shuts off and all of the lights flash and beeping.
For model number GLEQ2152ES1
PartSelect logo
Hello Rhonda, Thank you for your question. Our sources suggest replacing the thermal limiter under part PS419402 for your model to fix the issues. We hope this helps!

2 people found this helpful.

Was this helpful?
Thank you for voting!
Related Parts:
Lee
August 27, 2022
looking for a belt for this model
For model number GLEQ2152ES1
PartSelect logo
Hello Lee, thank you for contacting us. We have researched the model you have provided and have found that the part you are looking for is part number PS1148434. If you would like assistance placing an order, please contact customer service. Good luck with your repair!

Was this helpful?
Thank you for voting!
Related Parts:
Inge
November 7, 2019
What is error code 68? The controls come on by themselves and the display says error code 68. The controls come on constantly, so i turn off the power until i need the dryer.Thanks for your answer.
For model number GLEQ2152ES1
PartSelect logo
Good Day Inge. Thank you for your question in regards to your unit (Model Number GLEQ2152ES1). Based on our research, Error Code 68 means that there is a stuck key on your control board. If you are not able to free the key from it's position, the recommendation in to replace the control board. Hope this Helps! Best Regards.

Was this helpful?
Thank you for voting!
David
November 26, 2019
Dryer not selectable above low heat at any mode selection. Anything higher causes all right side lights to flash and beep.
For model number GLEQ2152ES1
PartSelect logo
Hello David, Thank you for the question. This sounds like an issue with a Defective Board PartSelect Number PS12724036 that needs to be replaced. Hope this helps!

Was this helpful?
Thank you for voting!
Related Parts:
  • 1

Common Symptoms of the GLEQ2152ES1

[Viewing 8 of 8]
Noisy
Fixed by
these parts
Fixing Fixing Fixing
Show All
Door won’t close
Fixed by
these parts
Fixing Fixing Fixing
Show All
Marks left on clothes
Fixed by
these parts
Fixing Fixing Fixing
Show All
Too hot
Fixed by
these parts
Fixing Fixing Fixing
Show All
Drum Not Spinning
Fixed by
these parts
Fixing Fixing
Show All
Lid or door won’t close
Fixed by
these parts
Fixing Fixing
Show All
Not Heating
Fixed by
these parts
Fixing
Show All
Leaking
Fixed by
these parts
Fixing Fixing
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Loud Squeaking
1. Unplug dryer from outlet
2. Using Lg. flat screwdriver, pry under the front edge of the top and release two spring tabs
3. Lift up top and tilt back out of your way
4. Unscrew two phillips scews on inside of front panel
5. Lift up and out the front panel. Two spring clips at bottom.
6. Rlease tension on drum belt at the motor. Access panel at rear of dryer.
7.Unscrew 3 screws from inside, center rear of drum.
8. Remove drum through the front of the dryer. You may have to spread the sides apart a little bit for it to fit
9. Lift up on the rear drum bearing to remove it from the bearing retainer. ( U shaped plastic socket)
10. unsrew 2 screws and remove the bearing retainer, ground ball. Ball retainer is on outside of dryer.
11. Vacuum everything--duct, blower, lint trap, ect.
12. Intall new bearing retainer and grounding ball, an assistant is helpful at this time, one to hold ball retainer on rear of dryer, one to screw it in from the inside
13. reassemble remainder of parts in reverse order.
Parts Used:
Rear Drum Bearing Kit
  • Frank from Boyertown, PA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Screw drivers
334 of 353 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
short circuit with a brasier metal support
Disconect the dryer from the main power source.

1) Remove the two screws from the rear / upper panel (below the control panel).

2) Snap the front side using a flat head screw driver.

3) On the inside front, remove two screws (one on each side) from the upper side and snap the door assembly off.

4) Remove the rear motor access panel (two screws) and appying tension to the spring remove the belt.

5) Pull the drum upwards (verticaly) unnapping it from the rear wall and remove it horizontally through the front panel.

6) Disconect the four leads to the heating element and remove the four screws from the rear of the dryer and replace the heating element.

Follow the same steps backwards to put the dryer together again.
Parts Used:
Heating Element Assembly
  • Juan Carlos from Weston, FL
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers
233 of 271 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Thermal Limiter opened
Unplugged Dryer.
Opened top of Dryer, over the drum.
Removed Thermal Limiter.
Tested the Thermal Limiter - found it was open.
Checked all vents and exhaust tube for lint build-up.
Replaced Thermal Limiter.
Closed top of dryer.
Plugged Dryer back.
Tested Dryer - it works.
Parts Used:
Thermal Limiter - Limit 220
  • Stephen from Newnan, GA
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers
244 of 320 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!