GGS30 - Overview
Models starting with GGS30
Click on the best match to narrow your results.
Keep searches simple, eg. "belt" or "pump".
VALVE
PartSelect #: PS8707103
Manufacturer #: 00411253
This valve controls the flow of water or gas into the appliance, opening and closing as needed for proper operation. Reliable valve performance supports efficiency and leak prevention. Replacing a mal...
$354.22
In Stock
Order within the next 5 hrs and your part ships today!
LENS
PartSelect #: PS8698456
Manufacturer #: 00189343
$20.89
In Stock
Order within the next 5 hrs and your part ships today!
TUBE
PartSelect #: PS8698345
Manufacturer #: 00189023
$86.82
In Stock
Order within the next 5 hrs and your part ships today!
SWITCH
PartSelect #: PS8714254
Manufacturer #: 00428049
$28.07
In Stock
Order within the next 5 hrs and your part ships today!
NUT
PartSelect #: PS8698313
Manufacturer #: 00188978
$32.76
In Stock
Order within the next 5 hrs and your part ships today!
Spark Module
PartSelect #: PS8737287
Manufacturer #: 00753257
$298.09
In Stock
Order within the next 5 hrs and your part ships today!
Cooktop Installation Bracket
PartSelect #: PS8698292
Manufacturer #: 00188954
This installation bracket is for cooktops. Installation bracket holds the cooktop in place to the surrounding countertop.
$52.53
Special Order
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Part discontinued by Bosch. Found replacement part at Parts Select
Removed knobs and venturies. Unplugged electrical inputs. Lifted top plate. Replaced potentiometer. Replaced parts and plugged in electric supplies. Tested. Piece of cake, except for locating replacement potentiometer.
Parts Used:
-
Charlie from INDIAN SPGS, AL
-
Difficulty Level:Very Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Wrench (Adjustable)
3 of 7 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
the lens did not fit It did not fit in the hole of the range top
I has to file the bottom edge on a slight angle so the lens would fit in the hole. Also I had to file the top edge cause it had little tabs and and also had to file the edge below the top of the lens then it would snap in so I have to say the woman I talked to said she guaranteed me it would fit and it didn't
Parts Used:
-
richard from HOPATCONG, NJ
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
1 of 5 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!