GDS18LBPW General Electric Refrigerator - Instructions

Slide it over the fill hose and just line it up and put it in the slot.

I matched the part I needed throught your web site. Then I called and spoke to a customer support person, and gave my personal information to her. I do not like giving my credit card numbers over the internet. Your site allows me to do that.

Replaced cap and reinstalled. But I used iron nail inside cover to hold right side because crack was at right hole and right part would not help.

easily popped the new one in.

Barry G was right on with instructions and expectations of the process to trouble shoot parts and how to replace. Barry also provide the right part numbers for replacement items. Thanks again Barry.

Removed old defrost heater, cut wire then put heat shrink tubeing on wire,spliced wires slid tubing over splice applyed heat. JOB NONE

Unplugged refrigerator. Removed relay by unclipping wire and pulling relay off compressor. Looked-up part number and ordered part. Replaced part and plugged in refrigerator.

Had to get behind the refrigerator and clean the drain out first and that took at least and hour. Just unplug the old motor. Took the old parts of the old motor, put them on the new one and plugged it back in.

-- Hardest part was removing the section to get into the Defrost Thermostat. Used a hand scraper to push plastic piece back wards (39 in parts diagram) once pushed back about 1/4" it then pops up and can come out (towards the front). Noticed that the evaporator was full of ice and the fan was working). Replaced Thermostat after defrosting evaporator... works like a charm.

Water was leaking on the floor from under the fridge and I noticed that the cubes were very small and the ice maker was taking much too long to make ice. After pulling the fridge out from the wall, I removed the bottom back plate (about 7 screws) and checked the ice maker refill tube that goes from the inlet valve at the bottom of the fridge (left side) into the ice maker at the top right side of the fridge. The 1/4" tube had split 2 " from the inlet valve where it makes a sharp "U" turn on its' way up to the ice maker. I turned off the ice maker by raising the handle on the ice maker and turning off the 1/2" supply tube from the house supply pipe. I then tried splicing the tube by cutting it at the split and installing a 1/4" barbed splice on the two ends, but could not get a water tight connection. I then decided to order a new refill tube from Parts Select. The part arrived in 1 day (FANTASTIC SERVICE) and I installed it in about 10 minutes with no problem. (GE was out of stock on this part.) To begin, I disconnected the old tube at the water inlet valve (just push in the quick connect and then pull out) and proceeded to disconnect the other end at the top of the fridge where the ice maker is located. The molded end is adhered to the back with a sticky adhesive and must be scraped off with a putty knife before it can be pulled out. Once this is done, the new refill tube goes in the exact same way. One caution- just be sure to test and adjust the length of the white supply tube (I had to lengthen it by 1 ") before peeling the protective paper off the adhesive. It must be long enough to reach the white plastic cup that fills the ice maker. The inlet valve end of the 1/4" tube at the bottom just pushed into the quick connect connection. I then turned the ice maker back on inside the fridge by lowering the handle and also turned the house supply valve back on. I waited for the ice maker to call for water and then checked for leaks. NO LEAKS- job done!

I order the parts and went from there. Actually a very nice friend of mine did the labor. It took longer to defrost it in order to get things running again. I was without my refrigerator for 4 months had I known the parts would be so reasonable instead of what a repair man wanted to charge I would have done it sooner. thanks