FGSC2335TF7 Frigidaire Refrigerator - Instructions

I took out the broken drawer and replaced it with the new drawer

slide old filter out and insert new one

Twist to remove the old one an twist to install the new 9ne

Partselect.com delivered the part very fast and the item was extremely well packaged. All I had to do was take it out of the packaging and slide the glass insert on top of the shelf. It was a perfect fit that exceeded my expectations. Thanks!

Ordered the shelves from partselect. Com and just replaced the new shelves in the space where the old shelves were.

slipped the shelf on to the bracket........done!

Use pliers to remove the broken support. Clear the remaining insert pieces with screwdriver/pliers and insert the replacement part.

just slid them in and gently taped the pegs in

The tabs were broken by kids it took 10 minutes to repair on all 4 tabs you have to remove the push pins completed to get the new tabs to fit right

The u tube instructions were exactly what is needed. I had to cut off the old plastic pipes. My pipe had threaded connectors. Pex push on connection is super easy. You don't really need a block of wood to cut it if you have a sharp utility blade. If if you are sure this is the problem this is a really easy fix. Steps 1 turn off water at wall unplug electric also 2. Disc line at valve on refrigerator 3. Remove 2 screws holding valve 4. Pull valve out and remove plastic hoses and electric connections pay attention to color of pipe and electric connection. Mine were color coded. Had to cut off thread connectors. Reattach in reverse order or do one at a time. Check for leaks.

Write down where tubing goes, wiring is color coded.

Well, after watching the video before ordering the part, I ordered the correct part. My wife had ordered the wrong part that I had to return and ordered the correct one. To install the glass you just take out the crisper above shelf and lay the glass in place. So simple.

Undo a few bolts unplug power and unhook water lines then recut all lines and push in to new value

Took the glass out of the shipping box and it just slid right in. It was a perfect match.

After sending PartSelect the info to their troubleshooting dept. about my ice maker, they recommended replacing the ice solenoid. I did so at a cost of $102. No change, turned out replacing the ice maker(did not purchase from PartsSelect) was the issue and works fine now.

So wasted $102. FYI the part took 6 days to arrive.