All Installation Instructions for Frigidaire Refrigerator FGHB2866PFEA

There is no power, due to the COVID-19 pandemic there no Tech support available,

My repair plan is to continue buying parts for it until is starts working. I notices a large rusty stain on the back of the refrigerator, so I replaced the Ice Maker. Then, I replaced the Evaporator Motor. Yet nothing will come on.
I called Conn's Home Plus where I bought the Frigidaire Refigerator back in February 2014. The Tech said that It needs a Board-main Power (computer part). So I it ordered from PartSelect. It is due here by July 20, 2020. The Parts and Tech cost is now over Five Hundred ($500) dollars.
HELP!! I need INSTRUCTIONS, HELP!!!
Albert F. Alfaro in San Antonio, TX.

Parts Used:

Ice Maker Assembly

Albert from SAN ANTONIO, TX
Difficulty Level:
Very Difficult
Total Repair Time:
More than 2 hours
Tools:
Nutdriver, Screw drivers, Socket set

3 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Thin, flexible edge on outermost door gasket was tearing from the main gasket, likely due to being rubbed when accessing refrigerator..

Gasket is held in place by an extrusion on the back side. Simply remove the old gasket and press the new gasket's extrusion into the track on the door.

Parts Used:

GASKET-DR,MAGNETIC FF GREY 36

Dennis from Oley, PA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Replaced door gaskets with new ones

Removed the old door gaskets by hand and attached the new ones by inserting the edges in the existing grooves

Parts Used:

GASKET-DR,MAGNETIC FF GREY 36

Andres from Golden Valley, MN
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

GASKET WORN AND LEAKING

SIMPLY REMOVE THE OLD GASKET PULLING LIGHTLY BY HAND
THEN PUSHING THE NEW GASKET BY HAND

Parts Used:

GASKET-DR,MAGNETIC FF GREY 36

Dennis from Lancaster, SC
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Filter wouldn't engage

Basically unhooked water lines and removed the screws

Parts Used:

MANIFOLD FILTER

Dennis from OLATHE, KS
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers, Wrench (Adjustable)

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Interface panel lights out

remove two screws under front trim, Remove trim and remove two screws in interface panel, Unplug three wires and plug them into new panel, replace two screws in panel and then replace trim and install the last two screws. Done...

Parts Used:

USER INTERFACE

Donna from CASTLE ROCK, WA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

ice maker is stuck on crushed ice.

We had someone to come and look at it and we were told it was the solenoid valve. The repairman unstuck it for us and said when it does it again, he would have to order the part. We took it upon ourselves to order the part and DIY. We replaced the part that we were told was the problem and "guess what" it's still not fixed. It's still shooting out crushed ice. Will have to call repair guy back out here to see what we did wrong.

Parts Used:

Refrigerator Ice Dispenser Solenoid

Mary from MAGNOLIA, AR
Difficulty Level:
A Bit Difficult
Total Repair Time:
More than 2 hours
Tools:
Nutdriver, Screw drivers

3 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

routine maintenance

slide old filter out and insert new one

Parts Used:

Air Filter

fred from Austin, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

time to change water filter

first, there many different water filters. your experience will be different according to your water filter type.

Parts Used:

Refrigerator Water Filter

Ronald from Warrensburg, MO
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins

2 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Ice Maker was making ice erratically

After sending PartSelect the info to their troubleshooting dept. about my ice maker, they recommended replacing the ice solenoid. I did so at a cost of $102. No change, turned out replacing the ice maker(did not purchase from PartsSelect) was the issue and works fine now.

So wasted $102. FYI the part took 6 days to arrive.

Parts Used:

Refrigerator Ice Dispenser Solenoid

Daune from OCALA, FL
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Refrigerator water dusoeswr stopped working

I removed the defective water valve. All wiring and tubing connectios were color coded.
It connected the water tubes and electric plugs to new water valve.
The water dispenser worked perfectly after I reconnected everything.

Parts Used: