FEFL88ACB Frigidaire Range - Instructions

I used a screw driver to pop the broken glide out and then snapped in the new one. The repair took all of about 30 seconds. It probably would have taken even less time if the former owner had not epoxied the broken piece in place.

Removed drawer and replaced broken and missing parts. Very easy when you have correct parts.

piece of cake. snapped right in.

the repair was simple and it was so easy to order thanks to your website my stove is as good as new.

They snap right into place in the holes at the front of the stove and the drawer is then slid back onto the glides and works properly once again.

I pul;led out the drawer and inserted the front glide in about 2 seconds and slid the drawer back in! Presto--fixed!

Popped out the old ones with a screw driver. Pushed in the new ones. Whole process took less than three minutes, super easy.

So easy! The drawer glides just popped right in!

I watched the video before ordering the part. When it arrived, I knew exactly what to do. No tools were needed. It took me 2 tries to get the drawer aligned properly but the whole repair took about a minute. The video was invaluable!

Found correct parts on Partselect.com, watched the instructional video, ordered the parts and installed them when they arrived. Very simple, very easy.

snapped new glide in place.

Pull stove out to get behind it,unplug temperature probe plug. Remove temp probe from oven by removing the screw holding it in place on back of oven. Cut plug off temp probe unit leaving as much lead wire as possible on plug end. Strip wires on new probe and end of plug wires(one quarter inch). Then I used two small butt connectors to join the stripped wires,one for each pair of wires. Two small wire 'nuts' may also be used as the connections are outside the oven and not exposed to the heat of the oven while it is in operation. Hope this helps the inexperienced 'do it yourselfers'--:)

Really a no brainer, but I do have to say that PartSelect customer service is excellent. My part was located and on it's way within a day and arrived a couple of days later.

Fed ex dropped the part off at 7 one night, had it repaired by 7:05. Popped the broken glide off, popped the new one in. Easier than easy. Took longer to empty the drawer and remove it than to do the repair.

Took no time at all to fix and is as good as new. Hooray!