FDPC4314AB0A Frigidaire Dishwasher - Instructions

just replace

The hose goes from the water inlet solinoid to the side of the dishwasher.Remove the kick plate from the bottom front of the dishwasher. Disconnect the water supply to the inlet of the solinoid valve (copper tubing on mine). Remove the screws under the counter top which hold the dishwasher in place. slide the dishwasher out from under the cabinet only as far as needed to expose the hose(about 1 foot). The hose is behind the insulation. Remove the hose clamps from both ends of the hose(solinoid outlet and side of dishwasher)Remove hose carefully because this is all plastic. Install replacement hose and clamps. The new hose is several inches too short and will not fit into the upper hose guide, just bend it underneath. Be sure to put hose in lower keeper on side of dishwasher. Attach clamps, tape insulation back in place, slide dishwasher back under counter and install screws under counter. Attach copper tubing to water inlet solinoid valve. Run dishwasher and check for leaks. Replace kick plate. Note: I had enough loose electrical wire to slide my dishwasher out. If you don't have enough wire to slide out the dishwasher you should call a repair man.

just pushed it into the crevice with my thumb

husband replaced wheels.

Thanks to PartsSelect exploded drawings, it was easy to identify and order the part. Installing was a case of just snapping it on the rack.

removed old hose by loosening clamps replaced hose reclamped

Took the gasket off and put the new one on.

The left-side dishwasher door spring snapped. The door was then noticeably heavy to open and close. To investigate the problem, I shut off the circuit breaker and the water feed. I removed the two screws that secure the top of the dishwasher to the counter, so I could pull out the unit and see the door springs. (TIP: remove the bottom metal panel as well to see if you have a flexible or rigid pipe for hot water. If you have a rigid pipe like I do you might want to be careful pulling the unit forward.) With the unit pulled forward I could see the snapped spring; it had actually shot up and was wedged between the unit and the cabinet. To to the repair, I attached the new spring to the door first. Then I closed the door so the spring was slack and used pliers to attach it to the bottom of the unit. (To access the bottom of the unit, you need to remove the metal panel at the bottom, as mentioned above.) I used the other spring as a comparison as to where to attach.

Your site is awesome.. not only show the parts but a video for the repair as well.. very smart site.. I will be back.. The repair was quick and easy. thank you..

Very helpful and was amazed how quickly it was delivered. Very pleased.

Nothing to it. Just inserted the iron stud into the center wheel and pressed the bracket onto the stud.

Removed old gasket,placed new one on pressing into place.Very quick and easy.Saw the youtube on how to do it.Unfortunately this was not the problem.now have a new dishwasher same brand.

Spotted the source of the leak at the first heating element under the dishwasher. Removed the brass mounting nut and it was cracked. Replaced with new part from PartSelect.com and the leak was fixed. Apparently the heating element gets so hot it tends to crack the mounting nuts, which results in a leak. Delivery time for part said 3-5 days - mine arrived one day after ordered!

Remove old gasket from tub, soak new gasket in hot water for a few minutes then install starting from center top of tub, when done installing close door for 24 hours, then try to see if leak fixed.

Ditto the other comments. Easy, great savings. Perfect. Thank you!