Models > FDPC4221AS1A > Instructions

FDPC4221AS1A Frigidaire Dishwasher - Instructions

All Instructions for the FDPC4221AS1A
121 - 135 of 256
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
needed wheels for the roller part of dishwasher
Just snapped the wheels on and attached the bracket to the existing part.
Parts Used:
Wheel & Bushing Assembly
  • Jeanette from Fort Lauderdale, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
original part was damaged and dishes weren't clean
Removed 3 screws, swapped parts - done. Wonderful feeling and saved a service call. Works great.
Parts Used:
Lower Spray Arm Support
  • ELIZABETH from ROANOKE, VA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Became loose, and spray arm burned alittle. Stopped working and water started over flowing.
Unscrewed the old arm, and watched a utube video to place back in properly.
Parts Used:
Lower Spray Arm
  • Kimberly from WILMINGTON, IL
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dishwsher leaking
Thought the problem was a faulty door gasket (there was a gap in the middle of it) so I ordered new(new one had a gap also) replaced it anyway - maybe it was worn out? Still leaked! Had to sit and stare at it and cycle it through. finally realized the spray arm had a hole in the end that was spraying directly into the gap in the door gasket. Hot glued the hole and it stopped so I bought a new spray arm - no leaky!
Parts Used:
Lower Spray Arm
  • matthew from west river, MD
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    More than 2 hours
  • Tools:
    Pliers, Screw drivers
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Water leak
watched a video, really easy fix. Solved the problem!
Parts Used:
Dishwasher Door Bottom Seal
  • MICHAEL from FT LAUDERDALE, FL
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dishwasher Leaks At Heating Element. Missing Door Spring
I removed the wires from the heating element. I removed the 2 brass nuts that had split down the side. I replaced them with 2 new brass nuts. Tightened with a wrench. I then installed the missing door spring. The repair itself took about 5 minutes.
Parts Used:
Heating Element Brass Nut Door Spring Spring Linkage
  • JOHN from PLAIN CITY, OH
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Wrench set
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The part list was melt from the hot water
Received the part and snapped it in place without any tools. It works great!!!
Parts Used:
Lower Spray Arm
  • Giovani from El Paso, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
3 of 7 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Brass nuts holding heating element in place had split
All you have to do power down the unit, then disconnect the power connections at the element and remove the old nuts and replace them with the new ones and tighten. Don't tighten too much, the element has a rubber seal that just needs the nut to snug it up.
Parts Used:
Heating Element Brass Nut
  • Jonathan from New Hope, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers, Wrench (Adjustable)
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dispenser failed to operate
Uncomplicated repair. Remove door, remove old dispenser, install new dispenser.
Parts Used:
Detergent Dispenser
  • GENE from BRONX, NY
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Pliers, Screw drivers
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Leaking tub seal
Just pulled the old gasket out and popped in the new. I did trim it too shrt however so be careful not to do that.
Parts Used:
Dishwasher Tub Gasket - Gray
  • Bob from Clinton, OH
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Sprayer arm design in newer model was not sufficiently cleaning
Pulled the completely empty bottom rack out, popped the old spray arm off, popped the new one on, and replaced the basket. Easy peasy. One of the easiest repairs possible IF it fixes the problem. (We had an older model Fridgaire dishwasher with this type spray arm versus the one that came in the new one and it worked great for 12 years. Falling back to it in a fashion was a logical attempt at a solution)
Parts Used:
Lower Spray Arm
  • Nancy from NUNNELLY, TN
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Bottom seal on door came out and melted on heating element.
Took me about 2 minutes to repair, no tools to repair, very easy installation repair!
Parts Used:
Dishwasher Door Bottom Seal
  • Danny from Collierville, TN
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Missing part
Just pushed it onto the rod that held the old one
Parts Used:
Wheel & Bushing Assembly
  • Michael from STEWARTSVILLE, NJ
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Plug for soap dispenser.
My future son in law did it. Looked at instructions on the app for the part. Didn't take very long.
Parts Used:
Detergent Dispenser
  • Janice from ELK GROVE, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Screw drivers
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Old gasket melted.
Watched installation video and followed directions. All went smoothly.
Parts Used:
Dishwasher Tub Gasket - Gray
  • Al from WOODBURY, MN
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the FDPC4221AS1A
121 - 135 of 256
Back to Top