EW30GC55GB1 Electrolux Cooktop - Overview
Sections of the EW30GC55GB1
[Viewing 4 of 4]
Manuals & Care Guides for EW30GC55GB1
Click to downloadInstall
Installation Instructions
(1.83MB)
Install
Installation Instructions
(2.03MB)
Manual
Owner's Manuals
(3.95MB)
Manual
Owner's Manuals
(12.23MB)
Wiring
Wiring Diagram
(0.09MB)
Keep searches simple, eg. "belt" or "pump".
Burner Mounting Screw
PartSelect #: PS2361437
Manufacturer #: 316540900
Sold individually.
$32.01
In Stock
Burner Cap- Black
PartSelect #: PS1991846
Manufacturer #: 316511502
Sold individually.
No Longer Available
Sealed Surface Burner Base - Dual - 18K
PartSelect #: PS2368544
Manufacturer #: 316525401
No Longer Available
Burner Knob - Black
PartSelect #: PS1992659
Manufacturer #: 318905201
Sold individually.
$191.74
In Stock
Common Symptoms of the EW30GC55GB1
[Viewing 2 of 2]Will Not Start
Fixed by
these parts
these parts
Show All
Gas igniter glows, but will not light
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Top burners were not lighting without a match
Was easy...I pulled oven out from the wall so I could get to the back.i used a nut driver to remove small silver cover.matched up wires to the never module and re installed.pluged oven back in and burners lit perfectly
Parts Used:
-
Earl from ALLIANCE, OH
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver, Pliers
3 of 4 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
burner ingnighter would not lite burner
Replaced the ingintion module, still did not work, replaced the burner complete with new ingiter , it now works but another one quit . the front right one has 5 ohms resistance ,replaced with new one with 0 ohms, the back left has 2 ohms resistance and now it does not work , will need to replace that burner allso. too bad you can't buy just the spark module for the burner.
Parts Used:
-
Wayne from Palestine, IL
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Pliers, Screw drivers, Wrench (Adjustable)
30 of 86 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Two of theTop gas burners would not spark
Took 6 screws out holding the top on from the sides. Lifted the top front, popped out the spark module, Took 6wires off & reversed the processed to install the new one. I was really amazed when I ordered it Wednesday and it arrived on Friday. Believe me I bookmarked this site.
Parts Used:
-
Robert R from Lewistown, PA
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!